Aluminium couleur titane Adapteurs roue avec vis de blocage - 6mm (12mm Hex)

• Overall
• Quality
• Value

Customer Rated

Sep 03, 2016

Bought 2 set sof these. Although they look good none of the 8 actually clamped onto the pin or axle shaft. Tightened the screw all the way down, and the hex slipped right off. The could work as hex adapters, but would need to be held in place by the wheel.

Would not purchase again

• Overall
• Quality
• Value

Customer Rated

Sep 01, 2016

I usually don't post reviews, but this product is too bad to pass.

I purchased the wheel adapters to use with a Tamiya TT-02, since original Tamiya aluminum hex hubs cost a lot of money.

As other reviewers are saying the quality is terrible. The screws seem too short and strip very easily, so you end up with an adapter that you cannot lock on the pin. This should be the main feature of locking adapters.

The worst thing that I have found however is that the groove where the pin should settle is machined at different depths between the left half and the right half of the hexagon.

This causes the adapter to lock on the axle with a wrong angle, resulting in a huge wobble of the wheel.

Note that I have purchased two sets of adapters and some seems to be machined better than the other, but they still have other problems like the screws that don't lock.

If you find a lucky set they may work a little better, but I advise you to save your money and buy some other brand adapters.

This is the first product I buy from HobbyKing that I totally dislike.

• Overall
• Quality
• Value

Certified Buyer Rated

Dec 14, 2014

not fit for tamiya. money lost

• Overall
• Quality
• Value

Customer Rated

Jan 08, 2014

Back in November 2013 i ordered these and received them marked 6mm, but measuring 5mm.

Made a warranty claim and after a month of mucking around and HK trying to get me to pay for them again they sent me a new lot.

These were also marked 6mm, measuring 5mm.

• Overall
• Quality
• Value

Customer Rated

Dec 15, 2013

The ones i received were marked 6mm, but measure 5mm.
Am reluctant to re-order until this is resolved.

• Overall
• Quality
• Value

Certified Buyer Rated

Aug 01, 2013

Good quality parts but pretty bad prcision... One stays in place but the three others don't!

• Overall
• Quality
• Value

Customer Rated

May 14, 2013

Perfect for Trx Slash rear. Good quality and fit. Use drop of blue thread lock to secure the small screws when installing.

• Overall
• Quality
• Value

Certified Buyer Rated

Feb 25, 2013

Hexa adaptery na kola pasuji i na HIMOTO trucka

• Overall
• Quality
• Value

Customer Rated

Aug 21, 2012

They look great, but precision is terrible. one of adapters does not fit into a pin, so I needed to shave an edge. Another does not accept screw well, so I tightened it a lot, but an adapter came off with wheel when I took it off.