Turnigy Marine 180A BEC Speed ​​Controller étanche avec l'eau de refroidissement

• Overall
• Quality
• Value

Valeur sure

Apr 18, 2018

Fort, fiable ras ...

• Overall
• Quality
• Value

Good, but only 2 caps on the wires?

Nov 28, 2017

First impression is good. But... The esc has only 2 caps on the powerleads? On the pictures it looks like there are more on it. I have not installed it in my boat yet so can't give a proper review so far. Anyone else tried the version with the 2 big caps on the leads yet?

• Overall
• Quality
• Value

Looks Good.

Sep 13, 2017

My first impression when opening the box was that this is a very impressive looking bit of kit that comes with plenty of good reviews.
I bought this speedo for use in my Pursuit so it should be more than adequate and leave some "in reserve" that may be handy if I decide to upgrade the motor and/or cell count in the future.
The plugs that came on the motor that is fitted in the Pursuit were too small to fit those that are fitted to this speed controller but fortunately the speedo came with a spare set of 3 matching plugs (complete with colour coded heat shrink).
I removed the plugs from the motor and soldered-on the bigger ones - but then found that they did not fit into the speed controllers sockets!!!!
After about an hour of very careful sanding with fine emery cloth (and constant check fitting) I eventually had the plugs fitting smoothly (but tight) into the speed controllers sockets.
I now have everything fitted into my Pursuit and when connected up the speed controller worked immediately and the motor was turning in the correct direction - so all good so far.
The auto set-up was a surprise but I wanted to program the unit to make sure I had full throttle and to remove the reverse function.
So far the speed controller has refuse to accept any programming commands from the RadioLink transmitter so I will keep trying and maybe buy a programming card as I do want to get the best out of this speed controller and to make full use of its built-in functions.

• Overall
• Quality
• Value

8 out of 10

Jun 14, 2017

Seems to be working well but shuts down over 120 amps with green light flashing, doesnt feel too hot. Maybe the 180 amp rating is a bit optimistic?

• Overall
• Quality
• Value

180

May 28, 2017

It is impossible to program this ecu with the transmitter, I can't enter the programming mode. When I run the boat it will only run for a couple of seconds before it shuts down and you have to go back to neutral position to start the engine again.

• Overall
• Quality
• Value

Marine 180A v3

May 10, 2017

I bought this ESC for my 820mm boat, it is very easy to install in the boat. (use super velcron) But to program it by using your transmitter a whole different ball game. I would def. recommend a programbox whit this ESC. Then you know for 100% sure your settings. I run it whit a 2200KV and it is like superfast. For the price their isn't any better for >800mm boats.

• Overall
• Quality
• Value

Marine 180A v3

May 10, 2017

I bought this ESC for my 820mm boat, it is very easy to install in the boat. (use super velcron) But to program it by using your transmitter a whole different ball game. I would def. recommend a programbox whit this ESC. Then you know for 100% sure your settings. I run it whit a 2200KV and it is like superfast. For the price their isn't any better for >800mm boats.

• Overall
• Quality
• Value

excellent product

Dec 12, 2016

easy to configure without a programming card
100% waterproof
a must have upgrade for any fast boat
get one.......

• Overall
• Quality
• Value

Certified Buyer Rated

Jul 21, 2016

one of the best ESC for marine RC boats

• Overall
• Quality
• Value

Customer Rated

Jan 10, 2016

This is the best ESC for boats over 800 mm. I have bought 5 because they are 100pcnt waterproof, tough, plenty of capacitors for long leads and have terrific punch. Don't hesitate - buy it.