Turnigy Nano-Tech Plus 4000mAh 6S 70C Lipo Pack w/XT90

• Overall
• Quality
• Value

Good

Mar 04, 2022

Compatte e potenti.

• Overall
• Quality
• Value

good

Nov 01, 2021

good lipo loads of power

• Overall
• Quality
• Value

Great power

Oct 21, 2021

Great power !

• Overall
• Quality
• Value

Great power

Feb 25, 2021

Great power , fast engine response

• Overall
• Quality
• Value

Lots of power

Jan 25, 2021

a little big but i have managed to fit these into my Goblin500... very powerfull LiPos... and weight is just right. I use two of these for 12S setup also on my Trex700...

• Overall
• Quality
• Value

another excellent battery

Dec 16, 2019

when you need a lot of energy, this is the battery you need. Use to start air conception tornado and works really nice

• Overall
• Quality
• Value

Same power as HD series, High IR, NOT worth the added $$$

May 30, 2019

Michaels reviews is spot on to what I have found. I bought these because they were inbetween the HD cost and Graphines. I LOVE the HD series and swear they are an underappreciated line/secret. I use these packs in my fast electric boats pushing 85+mph and saw NO diff in performance over the HD series. I too have noticed the IR is higher than my HD's with far more use on them. Bottom line: the Nano-Tech PLUS line is a bust. Stick with HD or go Graphine. I will say though that they do NOT swell and perform fine but again NO better than the HD series which are MUCH cheaper. Do waste your money on these Plus series.

• Overall
• Quality
• Value

todo bien

Apr 23, 2019

todo bien

• Overall
• Quality
• Value

Explosive power but time will tell how they hold up

Dec 23, 2018

I bought two of these packs for a high amp twin cat setup. Very good power but I am not sure how I feel about the cell matching. The IR is really high with some of the cells, usually after the cells break in after 5-10 runs the resistance goes down, especially when warm. I have cycled these about 5 times and haven't noted much of an improvement in cell resistance. For the price I expect less than 1-3 Ohms for a new cell even before a run, some of these were 4-6 Ohms.