Turnigy ™ GTY-313C Hélicoptère Cyclique DS / MG w / Case Servo Alloy 3,5 kg / 0.08sec / 20g

• Overall
• Quality
• Value

Perfect

Oct 30, 2018

Nice servo! Zero shaft clearance, strong, keep position under load, fast, very silent. Used on elevator for my 3,6m glider with no fears.

• Overall
• Quality
• Value

Great Servo for the dollar

Jan 27, 2018

Got 2 of them for a crawler. Very nice and powerful servo. One has a tiny slip so one star less for quality. But overall they are great value for a little money.
Also I found out that KST servo arms fit (DS315 type). Well done Hobbyking!

• Overall
• Quality
• Value

Certified Buyer Rated

Jan 20, 2016

I put on a Trex 450 pro, they go perfectly with the middle slot, that was my question ... so far not work very well and heated, at first one of them to a different noise, but with the use equalized. have very good finish and quality ... we'll see over time



los puse en un trex 450 pro, van perfectamente con la ranura del medio, esa era mi duda... hasta el momento funcionan muy bien y no calientan, al principio uno de ellos hacia un ruido diferente, pero con el uso se igualaron. tienen muy buena terminacion y calidad... veremos con el tiempo

• Overall
• Quality
• Value

Customer Rated

Aug 30, 2015

After running these servos on 450pro for few months, it does better than the 306. It improve both the torque and resolution as gear ratio increased in it. However still unable to find replacement gear, as it won't survive hard direct crash. The output shaft is really no slop comparing to 306. Had swap out all 306 to replace with these servos, the 306 will be using for airplane only.

• Overall
• Quality
• Value

Customer Rated

May 02, 2015

Very good performance for this price range, improvement in cyclic control with the increase torque. Same as TGY-306g but using different gear ratio, very tight tolerance with no slop in output gear. To be safe need to open the bottom casing to check and hot glue the wiring inside.

• Overall
• Quality
• Value

Customer Rated

Feb 08, 2015

Habe mir eines zum testen gekauft. Das beste Servo das ich in der letzten Zeit von HK gekauft habe. Werde mir noch mehr bestellen, und hoffe dass die dann genau so gut sind.
Das TGY-313C ist ein spitzen Servo. Fast kein Spiel, stark und schnell.
Sehr gute Verarbeitungsqualitt. Hat eine gute Rckstellgenauigkeit, wenn das Ruderhorn auf 10cm verlngert ist betrgt die Ungenauigkeit ca 1mm.
Das Gewicht betrgt ohne Ruderhorn 19,8gr.
Das Kabel ist 21cm lang.
Bei meiner Futaba Steuerung stellt es bei iedem Trimm-klik sauber und sehr gleichmssig an, das sieht man nur wenn man das Ruderhorn massiv verlngert.
Fast das selbe Servo wie das TGY-306G. Etwas strker dafr aber etwas langsamer.
Eines der besten Servos fr diesen Preis, die es giebt.