TXPA58002W5 5.8GHz AV Transmetteur Signal Booster

• Overall
• Quality
• Value

Excellent Booster

Nov 15, 2016

Install the booster yesterday and had a very nice FPV view. In my first fly go 1.5 Km far, and the signal was perfect in my goggles. I´m using a 500 mW TX, and use a 1000 mAH Lipo for 15 min. I will buy another Booster

• Overall
• Quality
• Value

Customer Rated

Sep 21, 2016

i use this. my Quanum Q58-6 's power is 777mw in 5645ghz (by ImmersionRC RF Power Meter) and with this booster, it measured 2327mw. it looks clearly boosting "mw" , but little disappoint than i expect. it say max input limit "600mw" but even though with777mw, it can't reach to 2500mw. what it say "max" out put.

• Overall
• Quality
• Value

Customer Rated

Aug 15, 2015

mucha potencia. pero el segundo vuelo se murio de golpe. no te puedes fiar de el.
el gasto en bateria es impresionante. se recomienda poner bateria adicional. logicamente aadiendo peso extra. no se si es recomendable o poner un emisor potente directamente.
por el precio es muy llamativo pero una vez en marcha no se si es muy util.
consumo de bateria exajerado.

• Overall
• Quality
• Value

Customer Rated

Aug 03, 2015

posat amb un raptor 1,600m. te un tamany mol reduit per la potencia que suministra. ficat amb un emissor de 200mw. amb dos allargos. aixo de ficar el emissor amb l'amplificador junts no te pinta de ser bo si reps un cop. el segons allargo conectat a la antena que tinc engachada a la cua. consum molt elevat. recomano bateria separada al menys de 2200mha i un osd per controlar el consum i poguer torna a casa abans que et quedis sense senyal de video. qualitat de video be.

• Overall
• Quality
• Value

Certified Buyer Rated

May 29, 2015

Wow this is mind blowing ,with a 600mw TX only 300 meter reception ,with this booster almost 2.5 KM, only down side it's high power consumption,but that was to expect ,for a 2.5W TX booster. You better power it from a separate extra battery if y not it will limiting your flying time .

• Overall
• Quality
• Value

Certified Buyer Rated

May 26, 2015

I did measure 3.1W output with 200mw input. Power consumption is 20W, 2A at 10V. Doesent get too hot, cooling is good.



You will need a HAM licence to operate this legally.