4 canali Trainer per Coach e Student (Dual RX Controller)

• Overall
• Quality
• Value

Customer Rated

May 06, 2016

This unit works very well. I used it to install two receivers to couple two transmitters to my FPVraptor training plane.
I am using the Turnigy 9XR as the trainer transmitter and the Turnigy TGY - i10 as the master/coach/instructor transmitter. I learned the following to help with the set-up:

Dont try to be clever. Set the channels on the transmitters to be the same as that of the board meaning: Ch1 = Air; Ch2=Elevator; Ch3= Throttle; Ch4 = Rudder. Follow all the wires to the receivers and this model with this set-up. Saves time trying to work out which channel on the radio/receiver is actually working.

Understand that each transmitter works individually and that trim settings on the Master/Coach do not transfer to the slave/pupil. Each transmitter is truly independently in control of the model.

Lastly, I did not set any of the transmitters to training mode, there is no need to as this unit switches control of the airplane from receiver to receiver.

This is a clever piece of kit which is easy to install and I hope to have many happy hours flying with it.

• Overall
• Quality
• Value

Customer Rated

Feb 11, 2016

Yesterday tested this system on the example of two electric aircraft .. It is liked me. If everything is properly connected - the system works immediately without any settings.
I have an idea for management two aircraft simultaneously with a single remote control.
Later, I will try to make a video about how to use this system.

• Overall
• Quality
• Value

Customer Rated

Jan 17, 2016

INITIAL REVIEW: I just opened the package and am installing it now. But, first thing, you should know the instructions are some of the worst-written I've seen. My guess is that I'll be able to install and test it using common sense, trial-and-error, and a lot of time. But, wow, it's pretty bad. For example, here is the last instruction, exactly as written:

"MARK: If you used it on oil airplane, you need to supply power to A or B port, via ESC is OK don't need a separate power supply."