Questa luce LED circolare ha 16 LED montati a un PCB in alluminio sostenuta, si tratta di pre-cablato per una spina stile JR.
16 elementi che ammontano a 7Watts LED.
Grande per illuminare i vostri modelli nel cielo notturno o l'aggiunta di illuminazione a bassa tensione per l'area di lavoro.
Tensione: 9-11v Dc
Montaggio: 2 mm di diametro, 35mm spaziatura
a perfect add on for night flying on your copter !!!Very bright. I would suggest for ease of use to solder a balance lead (3S) to the wires.grandiosa iliminacion que proporciona muy brillante excelente para un quad o un heliNice LEDs, but could do with a better heat sink. Runs on 11V drawing 100mA barely getting warm, but on 12V starting to heat up very fast. Had to switched off on 70C.posizionato sotto al quad ha un effetto spettacolare nella notte!!ordered two yellow and two blue. Only three leds on a yellow disk lit, all others on all four disks, were dead.Very bright but the voltage stated here is wrong. It will not light up at all on 3 S (11.1 V) and needs 4 S ( 14.8V) but it gets rather hot after a few minutes so I suggest you mount them where there is some air cooling. Guess they are made for 12VBought four of these LEDs and am very disappointed. The two yellow ones flashed and burned out as soon as I put power to them. One of the blue ones had half of the LEDs go out after a few seconds. The one that is still working is very bright and looks good.