Eccellente piccolo servo digitale per piccole applicazioni in interni. Potente, veloce ed è dotato di un motore coreless.
Questo servo è dotato di adattatore porta per soddisfare una varietà di ricevitori (JST 1.0 Tipo / 1,25 millimetri / JR)
Coppia: 0.50kg ~ 0.65kg
Velocità: 0,07 ~ 0.06sec / 60deg
Tensione: 4.8V ~ 6.0V
Treno di ingranaggi: ingranaggi uscita metallo
Tipo motore: Coreless
Collegare: JST connettore a-1,5 millimetri passo (Si adatta Spektrum Rx AR-6300)
* Nota: Tensione di funzionamento non può essere superiore a 6V.
Servo è dotato di accessori e una garanzia completa.
Velocità ( Sec / 60deg )
Coppia ( kg) ( min . 0.01kg )
Unit Weight (g):
A ( mm ):
B ( mm )
C ( mm )
D ( mm ):
E ( mm ):
( Mm ) F
I'm pretty happy with these servos, but know that only the output gear is metal, the rest are plastic. Also the adapter from the 1.5 to 1.25 had the black and white wires swapped. It is pretty easy to fix. One side of the connector has three little nylon bars that hold the pins in, just pry one up a bit to allow the pin to slide out, do that with the other one and swap them. This was to allow it to work with the little Orange receivers that are compatible with the Spectrum receivers. I don't know about others, but keep your eye out for a swap. Also Blue Arrow make a servo that is like this but full metal gears. It is the DO3018MG. I was real pleased that all the servos worked, in the past usually 1 of 3 of the Blue Arrows are defective. Progress. :)Servos perform good and fast. But quality of external housing is poor. Basically, its housing is kept together by stickers on sides and very easy to get disassembled accidentally. :) Had to re-glue them.Gutes servo ,aber Servohebel mu zustzlich verklebt werden passen leider nicht, darum nur 4 sterneI almost lost a plane because the wire is not soldered to the board very well and it shorted out.Excellent dans un EIM racer ! Prcis, lger et rapide.Used as a Blade 130x tail servo, fits great and holds the tail much better as the standard linear servo`s. Great!I ordered four of these. I had read that they should be worked without load for a bit to reduce failures.
Out of the box, three had random movements during their travel. It took a minute or so on server tester in auto sweep function for this to stop happening.
They seem fine now. I am not sure how common this is or if I should be worried.A real micro servo, smooth-running and fast. Hope it will prove sturdy.servo mont sur mon geebee eim 60 cm,
avec rcepteur ar 6300(compatible)
marche bien pour l'instant
Leider schlockern sie Servoarme auf dem Zahnrad.. Man muss sie mit etwas Gummi Arabikum fixieren. Dann geht es. Dan passt auch die Rckstellzentrierung.