CNC timone 2_Tray (M3) nero
Shoring: 2 Inserto cuscinetto
Servo: HITEC, FUTABA, JR
Questo vassoio dotato di doppi cuscinetti a sfera per il movimento ultra-fluido e preciso.
so why would you want this thing ?
ANSWER: Just think how tight you must make the pull pull system on your plane so you don't have slop Ok now you are pulling the out put gear on your servo side ways and 2 gears that's not parallel tend to strip gears so this takes of the strain on you servo horn and gears and the servo can concentrate on doing its job which is just to move the control surface not to keep cables tight as well it is light has bearings and you need the Alloy Push / Pull Elevator/Rudder Bell-crank
which is sold separately PRODUCT ID: RUD-Bcontinued...
just put my hitec HS-7954SH's into the tray to see if the screw holes line up,they dont even come close. the screw holes in the tray are to far apart for these servo and you will not get bigger servo's to fit either. I recommend not buying. dont waste your money !!!brought this for a extra 330 35pcnt. great item and very solid,though its no good for me. the servo openings dont match where it needs to sit,alos the nuts on the bottem are in the way which meens that 4 extra holes will need to be drilled to allow the tray to sit flat.
this is not a screw in and forget item. I need to do mods to the airframe to make it fit.I also cat get to the back of the tray to drill holes for fitment. for me,it was a waste of money!this item is really good, the finishing is superb , it is solid as a rock ,
i bought this item to use it on a extra 300 40pcnt and its just what i needed . excellent product for the fraction of the price of SWB .