Dassault Rafale Doppia EDF Jet EPOApertura alare: 830 millimetriLunghezza: 1.100 millimetriAltezza: 385 millimetriPeso di volo: 1400g upServo: 9gx5pcs o 8pcssistema di alimentazione: LEDT-68-1AP39x2Spinta: fino a 1350gFunzione: Ritrarre sistema di atterraggio, fondo scala funzionale prestazioni ala anterioreECS: 40A o superiore x 2Radio: 6CHBatteria: Li-Po 3S 11.1v 2200mAh x 2richiesto;
4 9g Servi
2x2200mah 3S lipo
TX e RX
one motor is big and one is litel smoel
Retract lanthing gear system does not fit in good the canards are not un the same hight one is up........
very nice and very nice looking on air went flyingas I can buy and download this model to Brazil, informed step by step the import procedureGreat looking EDF jet.
The twin fans are pre run and balanced at the factory. If you look under the cardboard support you can see a little sticker with the test data.
The retracts are the only thing that appears to be sub par. Getting the linkage to work smoothly without binding is a chore. I'm using a 8ch receiver with 3 of the channels for the gear retracts so I can set the travel in my radio.
HTX900 servos fit perfectly into the servo slots.
you'll need a servo Y harness for the esc's, and 2 short, 2 med, and 2 long extensions.
The control surfaces come prehinged and on mine are very stiff. They will need to be redone. Minor foam cutting was needed to fit the esc's. Sanding and cutting was needed to fit the landing gear. The hex rod that supports and turns the canards was binding very badly. The glued in support mounts needed to be broken out. Foam cut to fit them better and put back it. now it works smoothly. Packaging is very good, it arrived in perfect condition. Some minor extra work may be needed but don't let that stop you. This is a very nice Jet.