DYS Smart3 3 assi GoPro giunto cardanico con AlexMos Control Board (BaseCam)

• Overall
• Quality
• Value

Customer Rated

Apr 28, 2016

Just got this, worked pretty decent out of box no tune or anything. Sometimes it does not face the correct yaw direction, but if you push it into place it corrects it. I have not gone into the computer to tune or edit (may be something i can work out). Doesn't seem to need too much of a calibration out of box, but will be doing one soon to make sure. I would recommend as it seems to be a decent 3 axis gimbals on the cheaper side compared to other models. Time will tell though if it lasts (crossing my fingers), will update if anything major comes up.

• Overall
• Quality
• Value

Customer Rated

Feb 23, 2016

it looks to be a really good gimbal but BE AWARE input voltage betwen 9V and 12.4V !
( i wasn't noticed ibout that so now i have tou buy an UBEC ....)

• Overall
• Quality
• Value

Customer Rated

Feb 16, 2016

A good gimball, out of the box settings were OK, did some tuning and it works great, especially for the price, i have seen a lot of more expensive gimbals not having the performance of thisone. The Alexmos board gives you so many options that you can make this gimball do almost anything

• Overall
• Quality
• Value

Customer Rated

Jan 28, 2016

Nice gimbal for the price, carbon all round with a couple of exceptions like the gopro holder. Yaw axis works well unless connected to my computer, in which case it only works sometimes. Using it with a gopro 4 black and need about 5g of weight on the pitch motor to balance it out. The reason i dont give it 5 stars is the description labels dji phantom support, but it can only be mounted to a phantom by two standoffs. and then it hangs too low so you need bigger landing gear, preferably retracts. Might mount this on my Bumblebee frame.

• Overall
• Quality
• Value

Certified Buyer Rated

Jan 26, 2016

Not quite 'Plug and play' Took a few hours to install and finally set up the Gimbal.

• Overall
• Quality
• Value

Customer Rated

Jan 14, 2016

The manual is not very informative. I would like to know the pin assignment on the controller. Also the orientation of the imu sensor.
Eventually I was able to figure it out thanks to RCG. Making it work, updating the software was than possible. Sometimes the third axis (rudder ) does not work.

• Overall
• Quality
• Value

Customer Rated

Dec 10, 2015

Do not waste your money! Mine worked fairly good a couple of flights; after that the gimbal started to jump and shake like crazy. I reinstall firmware, but never managed to make it work.

• Overall
• Quality
• Value

Customer Rated

Sep 17, 2015

Very nice Gimbal. Had lot of trouble setting up initially as I reset the default setting and nothing seems to work after and it was lying on the table for the first 3 months, almost giving up. Then, it happened. Had been using for around 9 months now. Very happy with it. Just have to check the scrub screw that holds one of the motor as this sometimes become loose causing jello.

• Overall
• Quality
• Value

Customer Rated

Aug 10, 2015

I bought this gimbal thinking it would provide smooth video. It does to a certain extent, a lot of tinkering with Pids and firmware. I find firmware v2.3 seems to work best, with a gopro 4. I would have rather saved my cash and bought the Feiyu tech, which is a lot more expensive.

• Overall
• Quality
• Value

Customer Rated

Jun 20, 2015

it's pretty much a plug and play gimbal as written in the description. Mine worked well out of the box but to get it running perfectly, you have to put in a lot of time and effort.
I'm looking forward to the next testflights.