Il nuovo cavo Fatshark è il nuovo cavo standard per tutte le telecamere V2 Pilot CCD, Pilot HD e 600TVL CMOS. Il cavo è preconfigurato con il connettore Molex a 3 pin per la fotocamera e il pin 5 plug & play diretta con trasmettitori video Fatshark.
Lunghezza: 360 millimetri
I hate these little cables as they are so easily broken. Not the fault of the cable but just the setup. If you need to rewrite the blug to match the camera, just use a pin to push down the little metal piece on the large connectorPerfect spare or replacement cable for FatShark cameras...similar with the original one ,works perfecti will change the cables and will use on my skyzone tx
un fili per fpv plusplusplusplus plusplusplusplus plusplusI had purchased the FatShark PredatorV2 RTF FPV Headset System (great product for the money). But after a heavy crash the wire/connection into the plug (camera end) broke.
It was to delicate/small for me to be able to re-solder so this is a perfect replacement.
I have added a generous coating of hot glue to the back of both plugs and run it up the wires to the heat shrink for extra strength. (Not crash tested... yet)As per the original from FatShark many thanks,good valuefits perfect for my Immersion RC 5,8GHZ 600mW TXgood little cable, great to have a spare just in case something happenes to the one that dose come with the fatsharks,wish the molex connector was a bit stronger though as the wires do seem to get pulled out of it quite easily, would reccomend picking up two of these