FLIP32 F3 AIO-Lite Flight Controller with Built-in OSD
Now you can have a lightweight F3 Flight Controller with built-in OSD and Blackbox. The FLIP32 F3 AIO-Lite does it all on the one board.
Compared to the F1 MCU, it now supports more UART, runs faster and has a Blackbox data logger to help with fine tuning your setup to get the best performance from all components. The OSD gives lots of helpful information straight to the display.
The FLIP32 F3 has 16 times more flash memory (128kb Flash) than most other flight controllers and a floating point coprocessor for ultra fast loop times running the LUXFLOAT PID controller.
Using a PDB with an onboard current sensor allows the OSD to show voltage and current on the heads up display. Both Cleanflight and the OSD can be connected to via the onboard USB. A jumper is used to select which module the USB is being connected to.
The board is slightly longer than normal (at 40mm) but still fits onto the usual 30.5x30.5mm mounting holes and comes in at an unbelievable 7g.
• On-board OSD
• Blackbox data logger
• STM32 F303 MCU, Runs Cleanflight firmware
• 128Mb Flash (16Mb)
• PWM input (Pin headers)
• 8PWM output (Pin headers)
• Spektrum satellite receiver port
• S-BUS support (no inverters required)
• Built-in Micro-USB
• Buzzer port, RSSI Port
• WS2812B LED controller
Software: Cleanflight, Betaflight, Raceflight
Processor: STM32F303 CPU 32bit ARM @ 72Mhz
Memory: 128Mb Flash
Mounting holes 30.5x30.5mm
FLIP32 F3 AIO-Lite
Capacità ( mAh )