FPV corsa Drone PDB con OSD BEC per Naze32 / F3

• Overall
• Quality
• Value

Very nice PDB

Feb 14, 2017

this is basically clone of MXK PDB with OSD from BG, its cheaper too, works nice, it indeed have OSD built in, but be carefull when mounting it, one tiny capacitor is way to close to the screw hole (at VID IN contact) and if u tear it off like I did you will lose VID IN signal from camera.. luckily I was able to find and solder new one :) and now its working again :) also both voltages for cam and VTX are set to 5V but you can change those to 12V if needed by soldering together different contacts together, look for MXK board for more detailed info

• Overall
• Quality
• Value

Customer Rated

Aug 22, 2016

I recently purchased this board and the I must say the wire layout is nuts!!! Should have been 6 pads or 12 pads labeled /- beside each other , not 1pad for 3wire all( ) VCC and another pad for (-)GND then switch them on the other side of the board to GND and VCC. Next no easy way to access OSD menu or even away to tell you how to connect with FC. Next a manual would be nice as to tell you not to hook up wires to the VCC/GND on the Vout ports if your using a vtx that has it's own power cable and feeds the camera power also.
I got the set to work without plugging in the power lead for the vtx I let the V/out port power the vtx. Strange thing when I plug battery pack in to PDB board Vtx power all the way on. If anyone is using a V2 cricket from Rmrc don't plug the vtx in to the PDB board while using all the V/out ports as both V/in and V/out provide power. I think I need to plug the power lead wires into the V/out port so It can power the vtx and I get to turn it on and off when I choose. As of now when I power the board the v2 cricket turn all the way on (green light) and that's not suppose to happen. I will attempt this soon and hopefully figure out how to get the both boards talking to each other as far as battV / timer / and flight mode. I will post again soon once I work the kinks out!!