FPV trasmettitore & 1/3-inch PAL CCD

Compatibile con la maggior parte dei sistemi ricevitore video a 2,4 GHz questa fotocamera FPV e sistema trasmettitore è molto versatile e leggero e molto piccola.
La fotocamera utilizza un vetro di qualità lensed sistema di telecamere CCD di SONY.

A differenza di altri sistemi generici, abbiamo prodotto un cablaggio e incluso con la fotocamera in modo che il Tx e fotocamera saranno compatibili e la stessa tensione.
Se si acquista la fotocamera e Tx separatamente la polarità spina e tensioni possono essere molto diverse.

Incluso.
1 x SONY CCD 1 / 3inch Camera
1 x regolatore di tensione (ingresso batteria 3S)
1 x Micro Light Weight Trasmettitore Video (100 mW)

Spec fotocamera.

CCD tipo di sensore: 1/3 CCD a colori SONY
Pixel;
PAL: 500 (H) * 582 (V) (Incluso)
Sistema di scansione: la scansione interlacciata
Sincronizzazione: Sistema: Inter
Risoluzione orizzontale: linea 420TV
Illuminazione minima 0.01Lux / F1.2
DSP + CCD: CXD3142R + 405AK
Rapporto S / N: 48dB
Gamma Modifica: 0.45
Bilanciamento del bianco: Auto
compensazione del controluce Auto: Auto
Obiettivo: 3,6 millimetri
Audio: No
Tensione in ingresso: 9 ~ 12.6V
80MA corrente elettrica
Otturatore elettronico: 1/50 (60) ~ 1 / 100,000s
Uscita video: 1.0Vp-p video composito
Temp di funzionamento .: -20 ~ 50
Dimensioni: 38 * 38mm
Tempo di volo: Circa 60min / 3S 100mAh

FPV Tx Spec.
Potenza: 100mW
Regolatore di tensione: 3S -> 5v

Senza regolatore di tensione: 2 ~ 6V
Peso: 8g
Canali: 4

Uso: 1 3S LiPoly alimenterà la fotocamera e tramite il regolatore di tensione che alimenta il Tx su 5v. Avrete bisogno di una unità di 2.4Ghz il video di ricezione per ricevere l'immagine. Non includiamo l'unità 2.4Ghz Rx perché ci sono molti tipi e stili differenti disponibili e li riuniscono insieme non soddisfare la maggior parte dei clienti.

Carica video

Registrati per caricare video, per favore accedi o registrati

Temi

Ordina per

Argomenti più recenti

Pubblica un nuovo argomento

Registrati per scrivere recensioni, per favore accedi o registrati

WazzaG | Acquirente verificato

Overall
Quality
Value

Customer Rated

Jul 15, 2012

Haven't ranged tested this TX will do in 2 Weeks.
Caution check the polarity of the cable that plugs into the camera module before power up! My positive and signal wire were reversed, you can read it on the camera module. Tested at night worked a ton better than expected! Going to solder cloverleaf antenna to board and test range will document tutorial on my website www competefornothing com

Very impressed with this combo so far!

I am pretty sure these are the channels....
1 - 2410
2 - 2430
3 - 2450
4 - 2470

I have tested channel 1 with AIO 640x480 goggles sold here for $360

WazzaG | Acquirente verificato

Overall
Quality
Value

Customer Rated

Jul 15, 2012

Haven't ranged tested this TX will do in 2 Weeks.
Caution check the polarity of the cable that plugs into the camera module before power up! My positive and signal wire were reversed, you can read it on the camera module. Tested at night worked a ton better than expected! Going to solder cloverleaf antenna to board and test range will document tutorial on my website www competefornothing com

Very impressed with this combo so far!

I am pretty sure these are the channels....
1 - 2410
2 - 2430
3 - 2450
4 - 2470

I have tested channel 1 with AIO 640x480 goggles sold here for $360

Cliente | Acquirente verificato

Overall
Quality
Value

Customer Rated

Jan 02, 2011

I just received the NTSC version of this.. I can't say I'm very impressed with the quality. It's not sharp at all. The colors are very weak. I have a standard Rx that has a tune dial. No problems getting a signal. I tried it in the garden to about 75 meters. My receiver was hooked to my main PC and I streamed the results to my laptop.. I ran out of laptop range before the camera went off. It was a bit crackly.. but I couldn't adjust the tuning, and the receiver was indoors, so not the best test. HobbyKing need to supply instructions. I have never had any instructions with anything I got from Hobbyking.

nordwest | Acquirente verificato

Overall
Quality
Value

Customer Rated

Aug 10, 2010

As requested by many people - please find the usual 4 channel frequencies below:

CH1=2414MHz

CH2=2432MHz

CH3=2450MHz

CH4=2468MHz

Hope this helps -)

nordwest | Acquirente verificato

Overall
Quality
Value

Customer Rated

Aug 10, 2010

Good video quality and TX is incredible small. Without jumper the TX transmits on channel 4 (2469 MHz). I use it with a common 4 channel USB RX on my netbook.

A connection kit for Eagletree OSD would be great -)

I can recommend this set!

nemo | Acquirente verificato

Overall
Quality
Value

Certified Buyer Rated

Jul 25, 2010

Everything looks i'm still weighting for my receiver to test it, I had put it together to how it is set up it was easy but i don't know what the yellow, white and red wire are for.

Cliente | Acquirente verificato

Overall
Quality
Value

Customer Rated

Jul 25, 2010

I get only 4 stars due to lack of documintaion. great reange and decent cam for the little money I spent. works great with my FatShark Goggles.

Cliente | Acquirente verificato

Overall
Quality
Value

Customer Rated

Jul 07, 2010

Los canales del emisor se corresponden con los de la fat shark

Cliente | Acquirente verificato

Overall
Quality
Value

Customer Rated

Jul 01, 2010

here is a test http://www.youtube.com/watch?v=am8b1tFbkQA

Cliente | Acquirente verificato

Overall
Quality
Value

Customer Rated

Jun 15, 2010

A 500 m/watt 1.2 gig would be the best

900meg is used for cell phones so no good in SA and UK.

Caricare un file

Registrati per caricare i file.
Per favore accedi o registrati per iniziare subito ad aiutare gli hobbisti!

Impostazioni

Choose language

Impostazioni

Choose Currency

Impostazioni

Choose Country