FrSky TFR4 4CH 2.4GHz Surface / Receiver Air FASST compatibile
FASST 2.4G: Impianti (Modalità 7CH / Multi Mode) e Surface Systems (Modalità C1) (3PK 4PK / 4pks etc.)
Moduli TF FrSky: TF-8M, TF-14M
Compatibile con FASST 2.4G: Impianti (7CH Mode / Multi) e Surface Systems (modalità C1);
CPPM e RSSI (PWM) Uscita - Se CH3 e CH4 sono collegati da un ponticello, CH1 emette CPPM per CH1 ~ CH8 e CH2 emette RSSI (PWM);
Leggero e di piccole dimensioni;
Due opzioni di impostazione sicuro selezionabile.
Numero di canali: 4
Di funzionamento Gamma di tensione: 3.5V ~ 10V
Range di temperatura: -10C ~ 80C
Dimensione: 34 * 19 * 8mm
Product received defective!
I ordered 5 and 1 was defective.
HK gave me the run a round and will not replace faulty item. I spent over one hour with there online live chat.
RobertI have owned two more of these, used at 1km with my Futaba 14sg without issue, very small and light. Had many crashes without damage. I use it with the channel 3,4 pins shorted to put it into ppm sum mode for one cable going into my Naze32, works well.Gewicht 6,55g inkl 2 Antennen (145mm lang 122mm isoliert)
Gehaeuseabmessung 35x20,5x8,8mm (Steckerbuchsenhoehe 13,5mm)
Gehaeuse hat Schnappverschluss, Taster versenkti got 2 of these about 2 years ago for my car they work great, just got 1 few weeks ago the thing just shut off twice on me, was going fine then it just stop, lucky i did set the failsafe on my tx, 2 lights red and green both flashing don't know what does that mean. have to rebind to get it work again. don't know if the orange rx any better then this rx.great price receiver works perfect installed in my savage flux.....if u have nitro or gas then u can use 3 channels of it and if electric then u can use 4 channels of it...FrSky TFR4 4ch 2.4Ghz Surface/Air Receiver FASST Compatible.
Got 4 of this receivers Works perfectly with my 4PKS. Great product with great value.Je l'utilise avec ma Futaba 3PK et avant avec une 3PM.
Le recepteur fonctionne tres bien y compris pour des modles demandant beaucoup de prcision ( 1/12 et 1/10 Pan car ).
Il est assez lger et peu encombrant par contre il ne faut pas enfoncer trop fort les fiches car la carte electronique a tendance a bouger.
L'assemblage n'est pas aussi bien russi que du Futaba mais cela fonctionne bien.
3 X moins chre que le R603FF ou FS !!!!Boy,
This is too easy.
Use it for training purpose on my Futaba T8FG. Teaching any Futaba transmitter student.
- No need of the expensive Futaba wireless training module.
- No expensive cables because of the voltage difference between the T8FG and other transmitters.
- No prblem with distance between teacher and student.
Bind in second with Futaba 8FG. I use this receiver because I need clean setup for my quad. Now, I only need one servo lead for full 8 channel as there is CPPM feature in this receiver. So far, I have no issue with this receiver. I haven't tried RSSI output. The RSSI output is digital therefore RC filter is needed if fed to analog input.LOVE IT! Great deal, works great, smaller than FASST Receivers.
Just super impressed with this thing. Works great with my 3PKS