3 Kit GH2 / Tempesta occhi Brushless giunto cardanico Full Carbon (Mini DSLR)

• Overall
• Quality
• Value

OK

Apr 06, 2017

Gimbal is OK. However, the manufacturer makes a mistake when crimping the ball bearing because it is damaged. After installing the 14x8x4 gimbal bearing works like a dream.

• Overall
• Quality
• Value

OK

Apr 06, 2017

Gimbal is OK. However, the manufacturer makes a mistake when crimping the ball bearing because it is damaged. After installing the 14x8x4 gimbal bearing works like a dream.

• Overall
• Quality
• Value

Two axis, not three

Mar 09, 2017

Unfortunately it doesn't say, if it's a 2- or 3-Axis Gimbal.
Also the photos give no answer, because you can't see the area, where a yaw-motor should be seated.
If there was an explosion view at the "files", it would become clear.
I will do that later this day.
Now I have to experiment, to get a third axis running.
A bit disappointed.

• Overall
• Quality
• Value

Customer Rated

May 30, 2015

Got it, overall quality is pretty good. All elements are little dusty, I suppose they didn't clean this up after CNC cutting.
Very important!!! You must be very, very gentle with screws on clamps on 12mm rods (smaller ones) are tightened with m2,5x12mm screws and on the other side m2,5x5. If You overdo the tightening force You will damage thread. I damaged 4 threads. Clamp will hold rod but to be safe I need add longer screws.
Clamp got 14mm height 2mm carbon fiber plate on both sides.
These screws are little too short, so I suggest to but already with this gimbal longer screws like m2,5x14mm.

To HobbyKing: You can suggest producer to make this clamps of little stronger material or add longer screws.

• Overall
• Quality
• Value

Customer Rated

Jul 15, 2014

very bad support.

1 - bad fix sistem move anywhere
2- support max max max 400 g camera and little size if you use a big ottic you have a proble

no strong support u see problem when u can try make a good video