Anodizzato oro Double Sided di alluminio di CNC del tubo morsetto 14 millimetri Diametro

• Overall
• Quality
• Value

Customer Rated

Jun 24, 2015

A bit smaller than I thought by looking at the pictures, but they will fit my project perfectly.
Going to use these as frame mounts on a H-quad, probably three clamps per motor pair.

The screws included are about 4mm taller than needed to tighten the clamps, giving you plenty of room to add material both over and under the clamp.

They are decently machined, small drill shavings in all of the holes, but easily pushed through. No dents or other defects. I got three sets, 12 clamps in total.

I would not use these to clamp a motor down directly, unless you use 2 clamps per motor, or use less than a 15A motor. The bolts are 2mm, and larger motors use 3mm screws.
There is not enough room to widen the hole.