hexTronik PRO 36A BESC w / PC programmabilità

• Overall
• Quality
• Value

Customer Rated

Dec 02, 2010

This ESC is crap. Smoked after 10 flights. I pulled under 20 A, and it did not get overheated. So this is just another chineese crap.

• Overall
• Quality
• Value

Customer Rated

Nov 27, 2010

This ESC seems to come with the cutoff voltage set as default 3.0 volts. It really needs to be at 9 volts for a 3 cell poly? I can't imagine it resets itself when it reads the battery voltage? Anyway I reset mine to 9 volts.

• Overall
• Quality
• Value

Customer Rated

Nov 13, 2010

Mine keeps breaking down under power causing the motor to turn slowly. (single phasing I suspect). Give the esc a couple of taps and away it goes again. Obviously a loose connection somewhere. Had it apart and under a magnifying lamp but cannot see any obvious bad solder joints. Went over it with a soldering iron as much as I dare on something so small. Didn't do much good as fault remains.

I only bought this because the 30A Turnigy Plush was on backorder. I think I'll wait for the Plush. So should you.

• Overall
• Quality
• Value

Customer Rated

Nov 02, 2010

Ne pas acheter, rend l' ame aprs une breve incursion (15") 35 Amp. Les commentaires ngatifs des utilisateurs sont seuls pertinents !

Not to be bought : die after a short burst (15")at 35 Amp.

The negatives comments of several users are all (and the soles ones) fully justified.

• Overall
• Quality
• Value

Certified Buyer Rated

Jan 31, 2010

It became a little hot using a HXT 2730 1300kv outrunner, even when using 1/2 throttle. Despite this, it is very simple to program using th pc conector.

• Overall
• Quality
• Value

Customer Rated

Dec 14, 2009

great esc for the money . cheap and does what it is made to do . usb program work like a charm. will buy 3 more soon

• Overall
• Quality
• Value

Certified Buyer Rated

Dec 05, 2009

I bought this controller to another. He is pleased with its quality and performance.

• Overall
• Quality
• Value

Customer Rated

Nov 02, 2009

didn't even get the chance to try it out. first time i pluged it in there was a very large amount of smoke that came out of it...

• Overall
• Quality
• Value

Certified Buyer Rated

Oct 29, 2009

THis is a very tough ESC and is of good quality. ( A friend of mine was flying with drawing 52 amps and it survived. He shall remain nameless) YOU WILL NEED TO ADJUST THE CUT OFF VOLTAGE FROM 4.8 V(I think IT WAS) to at least 3 volts per lipo cell in whatever pack you are using, otherwise your lipos life will be much shortened. I think the default is for a 6cell nicad. IT does work fine without programming so you would not be aware of the problem. the issue has been reported to UH. A lot of the download info for the USB stick is irrelevent for the 36 amp ESC.

• Overall
• Quality
• Value

Customer Rated

Oct 12, 2009

I had high hopes for this item, but was left disappointed. The ESC didn't work well with my 35-36 1300kv outrunner (from here). The motor ran, but it started with a very jerky motion.

I put it on the GWS A4 75mm EDF with 35 amp at full stick. This ESC was overheated after 2 min in flight and power cut off. It isn't worth its high pricetag when the cheap stuff here works better. I'll not buy this brand ESC anymore - wasting my time and $$$.