dimensione HK450 pignone 3,17 millimetri / 13T (Allineare parte # H45059)

• Overall
• Quality
• Value

Certified Buyer Rated

Oct 03, 2015

combacia perfettamente con le corone

• Overall
• Quality
• Value

Customer Rated

May 07, 2015

Improperly drilled hole - in the middle. Is unusable. The picture is good but real life if in near top. This will strip whole main gear teeth.

• Overall
• Quality
• Value

Certified Buyer Rated

Jul 05, 2014

A must have pinion for 3D flying. I replace 12t, because of to low headspeed on my original Align Trex 450 SE V2.



It fit perfectly to Align 430XL motor...

• Overall
• Quality
• Value

Certified Buyer Rated

May 31, 2014

Good quality, properly sized bore.

• Overall
• Quality
• Value

Certified Buyer Rated

Nov 09, 2013

needed a reserve pinion for toolbox, tested it just to check quality - for 1 flight was good.

4 stars - shipping cost is disadvantage.

• Overall
• Quality
• Value

Certified Buyer Rated

May 01, 2013

A excellent value.A perfect fit.

Thank You, HOBBYKING

• Overall
• Quality
• Value

Certified Buyer Rated

Mar 05, 2013

Gleiche Qualitt wie Kit. Also einwandfrei.

• Overall
• Quality
• Value

Certified Buyer Rated

Nov 12, 2012

I use this pinion gear with Turnigy 450 H2218 motor in my HK450V2 helicopter

• Overall
• Quality
• Value

Certified Buyer Rated

Oct 24, 2012

Los he comprado varias veces y van bien duran muchas vuelos

• Overall
• Quality
• Value

Customer Rated

Sep 11, 2012

The H45059 align pinion fits only 3.5mm shaft motors, if your going for the align pinion, the HZ054 has a 3.17mm opening. Just make sure you know your shaft diameter before purchasing the align pinion.