HKPilot Power Module con connettori a T e 6 Pin Cable 150 millimetri

• Overall
• Quality
• Value

Ok Power Module

Oct 30, 2016

Decent enough power module. Thought one thing you should know is that the HK Pilot boards and attachments use Molex Picoblade 1.25mm plug (White), they do not use the Hirose DF13 plug (Beige).

• Overall
• Quality
• Value

Customer Rated

May 09, 2016

While the 5v output of this module should be 5.25v, this module is actually outputting 5.50v. The pixhawk/hkpilot board detects this overvoltage condition and faults the board.

• Overall
• Quality
• Value

Customer Rated

Feb 20, 2016

Soldering quality is disgusting! If you're planning to use the cables/ T connectors, do yourself and your craft a favor by re-soldering them.

On the positive side, it works beautifully and the DC-DC converter piggyback board is of great quality.

• Overall
• Quality
• Value

Customer Rated

Oct 20, 2015

Works as advertised.
I replaced the input T connector with XT60 and soldered directly to the PDB the output wires. Nice thick 12awg wires.
For Arducopter I had set a value of 17Amps/volt but I think 12-13A/v should be better.
The 5V SBEC was kinda in my way, trying to fit it inside a Trifecta frame, where the PDB is, so I removed it, connected it with wires (looks like only 4 out of 5 pins are used) and placed the regulator somewhere else.

• Overall
• Quality
• Value

Certified Buyer Rated

Aug 29, 2015

I am using this on the HKAPM micro, with slight modification to the cord. It worked right out of the box, with minimal setup through the Mission Planner software.

• Overall
• Quality
• Value

Customer Rated

Nov 28, 2014

BE CAREFUL and check this Power Module before installing. I installed without checking and immediately smoked it. After the smoke cleared I found the positive (Red) and negative (Black) leads on the output side were reversed. The Red lead was actually negative and the Black lead was positive. The input side was wired correctly.

• Overall
• Quality
• Value

Certified Buyer Rated

Jul 17, 2014

Cosa posso dire e un power module

• Overall
• Quality
• Value

Customer Rated

Jul 04, 2014

WRONG CABLE!!!!! the cable you see in the picture and actually shipped with the kit, does not fit the hkpilot board connector...... you can tell me what to do ????

• Overall
• Quality
• Value

Certified Buyer Rated

Mar 30, 2014

I had to get the one with T connectors ...So a bit of soldering for me .

BUT

EVERYONE SHOULD DOUBLE CHECK THE SOLDERING ON THESE AND Really TAKE 5 MINS TO REDO THEM .

Otherwise perfect Item cannot miss the amp/volt readings any more

• Overall
• Quality
• Value

Certified Buyer Rated

Dec 09, 2013

Get this one if you don't want hassel of powering up the board and you get the voltage data for FPV as a bonus!