micromotori di alta qualità. ferita di precisione con filo d'argento-rame e ultra lamierini hard-stampa.
Prestazioni estreme ed efficienza per il micro aereo.Spec fabbrica.
Kv: 4000rpm / v
Gamma Lipo: 1 ~ 2S (3,7 ~ 7,4 V)
prop consigliata: 3020
Corrente max: 2A
Burst corrente (10sec): 2.5A
Peso: 3.1g (tra cui il Monte e fili)
Albero: 1,5 millimetri
lunghezza del pozzo: 6mm
Dimensioni: 13 x 10mm
Dati di test:
3020 prop (consigliata)
Per aereo 30g 3D e 60g di volo normale.
Kv ( rpm / v )
Correnti Max (A)
Potenza ( W ):
Lunghezza B ( mm ):
Can Lunghezza D ( mm )
Max Tensione (V )
Albero A ( mm ):
Unit Weight (g):
Diametro C ( mm )
Lunghezza totale E ( mm )
Resistenza ( mh ):
These motors are okay, however the leads are contained within a single insulated cord. Not sure how long they'll last before they heat up and short out.Gut fr Depron HallenfliegerA good choice for outdoor use!
O.k., not one allone. But 4 of them together power a model of 200g absolutly satisfying.
The only problem to solve is the props.
There are airscrews needed with small diameter and huge pitch, 2,16"x3" e.g.
But thanks to 3D-printing this is not longer a problem.
Birds like the Armstrong-Whitworth "Atalanta" with a span of 55 cm are possible.
As I said: outdoors!I have done some thrust testing with various propellers on the AP03-4000kv motor in the video below
Works good on a 1s LiPo system with certain props and batteries like GWS 5030 prop and 160mah Nanotech on a XP3A ESC.could only get this working for a few mins. wires seem way to thin to work with. need to be slightly thicker HKIt gives about 30 grams of thrust on 1 cell with a 4025 GWS prop.
Some wobble in the bell, but it seems to run smoothly enough.非:常:に:良:い:製:品:、:非:常:に:良:い:Best in 3 Gamm class. Combine the 4000 KV with an Kyosho Prop (e.g. Fly Baby ) result 45 Gramm thrust with 1 cell 160mah/3,7V 1 Gramm HK esc. application and the machin runs about 9-12 Minutes full throttle.
You have to ream up carefully to install he prop!
I use this powertrain in a DIY Motorspatz 600mm wingspan 54 Gramm flying weight.I use this motor AP03 with 5A 1S ESC.
It works fine with Lipo single cell.
and i rebind the wire and work fineNice running little motor, not what I had hoped for power wise on 1s.