KD sostituzione dell'albero Kit 20 -__ M

• Overall
• Quality
• Value

Certified Buyer Rated

Mar 23, 2012

I ordered this shaft as a solution for replacing the shaft on my D2830. The diameter spec is good. I was aware that it is a little shorter than the original in my motor but I use a particular prop adapter that does not need a long protruding shaft. If you need similar, then go for the next size up.

• Overall
• Quality
• Value

Certified Buyer Rated

Nov 24, 2011

I use this for my D2826-10 1400kv and fit perfetly, i will buy again! I think work properly for all D2826 series

• Overall
• Quality
• Value

Certified Buyer Rated

Nov 09, 2011

gute qualitt super preis

• Overall
• Quality
• Value

Customer Rated

Sep 30, 2010

recomended replacement part after an hard landing (aporrizajing je, je)

• Overall
• Quality
• Value

Customer Rated

Mar 21, 2010

Hello

Apparently HK do not always give the size and length of shafts. If this one is 46.5mm long it's perfect but I'm looking for A 3mm dia. Could you tell me if it is the case for this one, or how I can find one in HK's site. I've already bought three 3mm ones, but they are too short. Thank you for helping.

• Overall
• Quality
• Value

Fits the KA400H

Nov 14, 2007

I used this shaft as a replacement for the KA400H, as Hobbycity doesn't provide a direct replacement. It fits perfectly, but does not have a flat on one side. This makes it ok for mounting a prop, but not for mounting a pinion.