Drop em, em in crash, sopra la carica / scarica em, carica em veloce o si dimentica di spegnere il caricatore! Queste cellule amano essere abusato.
Totalmente sicuro dal fuoco e resistente ai incurante di carica / scarica. Queste cellule sono molto più robusto di Lipoly ed eccellente per le applicazioni più grandi.
Dato che le cellule possono essere soggette a 5A enorme per cella, tu sei in grado di carica deve più veloce, il che significa meno confezioni al campo!
Composizione chimica: LiFePo4
Scarico costante: 15C
Scarico di scoppio: 25C +
Max corrente di carica: 5A per cella
Tensione di carica: 3,65 per cella
Scarico Fine tensione: 2v
Capacità Min: 2700mAh
Ciclo di vita: oltre 1000
Si tratta di cellule FP, non F.
serie F hanno una scarica 5C. FP sono 20C
Capacità ( mAh )
Ca a l'air de marcher pas trop mal mais les mien prennent 2300 avec l'imax B8To continue my eralier review: the ceels are not too impressive when it comes to delivering acc to the specs. One has to use 4 instead of 3 cells to get decent performance alike a LiPo 11.1V pack. Also the capacity comes nowhere near the 2.7Ah: 2.3Ah max. (with an Ansmann Li-Ion charger).
Also I have a hard time getting more than 30A, instead of the rated 54 Amps.
I use the cells as an 6s pack in a funtana S40 with a Hacker A50 motor amd a Ramoser 3 15,2x6 propp. After 2 minutes running with throttel in half position i have 17V and 25A, throttel full are 15V and 43A. I discharged the batterie to 13V- charged it up to 22V with the fill of 2250mAh- it is ok for the money.LiFePO4 is one of the best chemistries among the latest battery technologies.
The main characteristics are high charge- and discharge rates as well as a good natured abuse behavior and a decent lifetime. However, the energy density is not as good as other lithium chemistries but this can be accepted for all the outstanding advantages. Please keep in mind that these LiFePo4 cells will be very stable and may not even need a balancer if treated well. The price is quite good and a good option to the rather expensive A123 cells which can be considered as similar cells with equal ratings.Tested as 4S pack, drawing solid 32A
with voltage depression at 10.5V. This
is similar to good lipo 2200maH 3s1p
pack that delivers 36A @10.5V under load.
Considering it as A123 alternative it is not too far behind.
Temp @ end of test(fully depleted) was
Held voltage @10.5V for most of discharge. Great for 2P apps for large
aircraft...u will get solid 60A
Also will gradually slope off voltage at end of capacity, not sudden dump.
Drew out close to 2600maH for total discharge.
Have not tested charge capabilities yet
or cycle life....The reel spec tell nominal 2500mah and min 2300mah with max charge to 4.1V cccv
i tested it with 5 cycle zero cutoff and the cell perform very good with 300mah lost only at 25Amp
at 6.5A the charge is very short and i charge it cc to 4.1V and stop and the cell reach same mah than cccv charge to 3.7VTo all the guys complaining about the lower capacity:
Did you discharge the cells to 2.0 Volt as stated from the manufacturer?
The original A123-cells can only be discharged to 2.5 Volt and that's the difference.Yes....
But only 2200mah.
But only 2200mah.
-> Easy to solder!
-> The Capacity is only 2300 mAh!
-> 3s pack test with TR 3542-B 1250kv, Propeller APC 12x6 E, Amps 44A, Whats 330W.
-> 4s pack test with Emax BL2820-07 920kv, Propeller APC 12x6 E, Amps 34A, whats 380W.