Matek Systems F722-STD Flight Controller w/ OSD and Barometer

The F722-STD is the latest flight controller from Matek, it has a built-in Betaflight OSD, BMP280 Barometer and up to 32k gyro performance. The board runs a high speed 216MHz STM32F722RET6 MCU, 6-Axis ICM20602 gyro and has a bottom mounted Blackbox MicroSD slot. This FC runs on Betaflight and the MatekF722 target. The board is compatible with the optional FCHUB-6S PDB or FCHUB-VTX board for a very compact build.

This board has very many features and is of a high specification, please see below for the complete list. Make the podium everytime with this up to date flight controller that will get the best out of you and your racing quad.

Features:
• 3 x LED's for FC status (blue/red) and 3.3v indicator (red)
• 7 x PWM/Dshot outputs without conflict
• 5 x UART's
• 1 x Group of G/S1/S2/S3/S4 pads for 4in1 ESC Signal/GND
• 4 x Pairs of corner pads for ESC Signal/GND connections (Dshot compatible)
• 1 x Side press button for BOOT(DFU) mode
• I2C1 SDA and SCL
• 16Pin bottom mounted FFC Slot for FCHUB-6S or FCHUB-VTX connection
• F722 has built in inverters. SBUS, DSM, IBUS, SUMD can be connected to any unused UART_RX
• FrSky SmartPort, Tramp & Smart Audio can be connected to any unused UART_TX
• S6 pad (PA8) can be resourced to Camera Control
• PWM pad (PB8) can be resourced to Camera Control

Specs:
MCU: 216MHz STM32F722RET6
IMU: 32K ICM20602 6-Axis accelerometer/gyro (SPI)
Max: 32K Gyro update & 32K PID Loop
OSD: BetaFlight with AT7456E chip
Blackbox: MicroSD card slot (SD/SDHC)
Barometer: BMP280 (12c)
VCP: UART1, UART2 , UART3, UART4, UART5 
PPM/UART Shared: UART2 Rx
Outputs: 7 PWM/DSHOT Outputs
Battery Voltage Sensor: 1:10
Current Sensor: No (FCHUB-6S, FCHUB-VTX option)
BEC: No (FCHUB-6S, FCHUB-VTX option)
LDO 3.3V: Max 300mA
12C1 SDA & SCL: Yes
Camera Control: Yes
DAC: Yes
WS2812 LED Strip: Yes
Beeper: Yes
RSSI: Yes
Dimensions: 36x36mm with 30.5mm mounting holes
Weight: Board 7g, standoffs 2.5g

Included:
1 x Matek F722-STD board
2 x 0.5mm x 16pin FFC ribbon cables
4 x Rubber anti-vibration standoffs

Please note: A User Manual is available under the "Files" tab.