Diventa fornitore Blog Nuovi oggetti
Registrati

Prezzo totale

0,00 €

Carrello della spesa 0 Carrello della spesa 0 Loading...

Mini Power Distributor DP BEC

Generating Links

Mini Power Distributor DP BEC

Prezzo:

Now save risparmia 0,00 € 0,00 €

76,23 €
Già acquistato Discontinued Product

Please continue searching for a similar product.
SKU:
373000009-0
Spedizione gratuita? Clicca qui per saperne di più!

Min Power Distributor UBEC adatto ai modelli 30cc più alimentati a gas.

Questa unità ha grandi caratteristiche, tra cui: ingresso doppia batteria, 5v isolato lineari RX BEC, 20 tensione Amp regolabile UBEC su tutti i canali di uscita, 8 canali di ingresso RX con doppia uscita su ogni canale - semplificare le superfici di controllo a doppio servo.

Grandi inclusioni sono il regolatore 5V lineare indipendente che fornisce una fonte di alimentazione separata per il ricevitore, otticamente isolate CDI potere e integrato uccidere accensione a distanza. fonti di alimentazione del ricevitore, servo e CDI sono completamente isolati gli uni dagli altri.

Questo è il primo sistema di alimentazione Distributore di sicuro nido ricevitore all'interno della distribuzione di energia 'block' accorciando in tal modo tratte di cavo, l'aggiunta di una protezione per il vostro tutto ricevitore importante e eccesso di velocità impostato tempo.

Caratteristiche:
• 5v lineare RX BEC
• 20 Amp Servo UBEC
• Gli utenti di tensione UBEC regolabile
• 8 canali di ingresso (+1 CDI taglio)
• 16 canali di uscita
• LED di controllo 5 di stato
• vassoio ricevitore imbottito e Montaggio sicuro
• CDI alimentazione isolata
• CDI accensione a distanza (taglio a distanza)
• CDI spia di stato dell'alimentazione
• CDI terminale di uscita di potenza
• monitor di tensione CDI LED

Opzionale: visualizzazione della tensione di ingresso / uscita con interruttore di alimentazione esterna

Spec:
Canali di ingresso: 8 (+1 CDI Cut)
Canali di uscita: 16
Tensione in ingresso: 6V-13V
Servo UBEC corrente: 20A (30Amp Burst)
Tensione di uscita: 4.8-9.7V (regolabile dall'utente; default è 5.2V)
Potenza RX: 5v bec linear
Temperatura di esercizio: da -20 a 85 gradi C
Peso: 80g
Dimensioni: 116mm x 88 millimetri x 13mm

Carica video

Registrati per caricare video, per favore accedi o registrati

Temi
Ordina per
Argomenti più recenti
* Nickname:

* La tua risposta:


Si prega di inserire il testo mostrato nell'immagine nel campo sottostante
*Codice di verifica:
Annulla
Invia
Pubblica un nuovo argomento
* Nickname:

* Il tuo argomento:



Si prega di inserire il testo mostrato nell'immagine nel campo sottostante
*Codice di verifica:
Pubblica argomento

Registrati per scrivere recensioni, per favore accedi o registrati

J.A. | Acquirente verificato

  • Overall
  • Quality
  • Value

Good, but be careful

Dec 21, 2018

A very nice device. But it involves a potential danger: the 5V power supply to the receiver has only 1A. This is just enough for the receiver and the internal ignition switch. But it is not enough for powering any other device from the receiver. I tried it: already with 1 servo the voltage-drop causes the receiver to stop working. So: DO NOT CONNECT ANY EXTRA DEVICE (Servo, ESC, SBUS Decoder etc.) TO THE RECEIVER!!
But there is a “workaround” if you want to connect additional devices: use the 20A power supply and to achieve that you have to do the following:
- disconnect both (!) red wires from the servo-connectors ;
- take a short female-female Futaba-lead and remove the black (ground) and white (signal) wires completely;
- take, on 1 side, also the red pin out of the connector and put this pin into the middle (!) position of one of the servo connectors;
- put the other side of the servo-lead into one of the (double) servo slots.
I did not cut away the two loose red wires but did put a shrink wrap over the pins. By doing that it is possible to bring the power supply back to its original state eventually.

Douglas | Acquirente verificato

  • Overall
  • Quality
  • Value

Almost the same as the yellow one.

Oct 17, 2017

The only difference I can see between this one and the yellow one is that this has 20A bec and the yellow has 30A bec. Then why is this more expensive?? I don't know, maybe cuz black is "cooler"..?? Works great for me, dual battery supply, adjustable bec voltage, I set mine to 6v. Easy to set with a simple voltage meter. It would be nice if it had led V display, but that would add more $ and not really neccessary, imho. I will get another for my next 30cc bird, maybe the yellow one, but I don't really need 30A bec!

Jorge | Acquirente verificato

  • Overall
  • Quality
  • Value

Question

Jan 21, 2017

Excuse my ignorance Which batteries do you recommend for use with 8 standard servos?
Thanks :)

michael | Acquirente verificato

  • Overall
  • Quality
  • Value

NO MORE POWER PROBLEMS EVER AGIN!!!!!

Dec 15, 2016

i have this ajustable power distributer in all my planes its the CATS MEE-OUH !!! TWINN BATTERY ADJUSTABLE POWER THERE OUT THERE FOR A HECK OF ALOT MORE$$$$$$ LIKE TWICE THIS PRICE. GET ONE AND YOU WILL NEVER HAVE A POWER PROBLEM AGIN !!!! FROM THE AVIATER UNCLE MIKE IN MENDOCINO CALIF

Patrick.Jurek@al | Acquirente verificato

  • Overall
  • Quality
  • Value

Customer Rated

Nov 13, 2015

Gute Akkuweiche Funktioniert super fr ganz kleines Geld.

Benutze Sie in einer 2,70m Extra mit 10 Servos auf 8,4 Volt

DrifterTR | Acquirente verificato

  • Overall
  • Quality
  • Value

Certified Buyer Rated

Jan 26, 2015

It is the best product for power distribution. Going to use on 1/4 piper cub

File dei clienti
Altimètre.pdf Download [558]
german manual Download [13]
Caricare un file

Registrati per caricare i file.
Per favore accedi o registrati per iniziare subito ad aiutare gli hobbisti!