modelli F3A sono progettati con un solo lavoro in mente, per volare bene! Il Monolog è un modello osservare acrobatico ben ragionevoli e attraente che può essere in aria a basso costo e rapidamente.
La cellula è balsa e la copertura attraente è stato applicato sapientemente, il monologo presenta anche un cappuccio in fibra di vetro ben dipinto e ghette ruote in nylon dure. Per praticità, il monologo presenta un plug 2pc in ala e un tubo di un'ala CF, l'hardware è eccellente e dispone di barre di controllo CF e corna di controllo GF. navi modello come il monologo rendono brillanti modelli sportivi mosca in quanto in grado di gestire un po 'di vento e indipendentemente da dove si vola, fanno modelli superbamente pratici acrobatici, soprattutto a questo prezzo!
Apertura alare: 1.200 millimetri
Lunghezza: 1.300 millimetri
Peso di volo: 1200g
Il proprio 4 canali TX / RX
35 millimetri Brushless Outrunner 900KV o sotto
4 x 9g Servo
40A ESC w / BEC
2200mAh ~ 2650mAh 3S Liploy Batteria
A great little pattern practice plane - no rudder/aileron couple required so flat cicles and sustained knife edge very easy. Slowrolls for as long as you like. Spins and snaps very precise.I like it alotterrible quality....i had to keep modifying things to make it workFlies ok, very stable in the air - but beware for missing assembly parts in the box for this ARF version and wrinkled attached ora-cover - choose 4s setup forhi, first of all I had more than 40 ARF from HK before, but this one was the worst, for the value its fair as its only 70$ which is not bad at all, my set up was Turnigy 3648 850kv, APC 13x10, HK 80A ESC, 4 Turnigy MG90S Metal Gear Servo, Turnigy 2200A 3S 40C. 1- This is not a pattern plane, more to the 3D side. 2- The quality is ****, the worst I seen. 3- No way to fix in the canopy, had to tape it before each flight. 4- very ***r landing gear, will bend with each take off and landing. 5- The wing tube diameter is wrong, have to sand the tube inside the plane, by the way its a ***r card board tube!!! 6- Stupid way for the Elevator and Rudder servos to put in!!!!!! 7- The wing doesn't fit in the fuselage, a lot of sanding and it won't fit perfect at the end too. 8- After a lot of work and effort, it flied well, can stand wind, but its not pattern, with the 3D elevator supplied its like a mixed pattern 3D plane, nothing special in it. Last issue the wing bolts are a disaster as they are a small piece of ***r ply wood and not fixed strong to the wing and I didn't notice this as I never expected that, which broke during rolling and one wing rotated which caused a crash in its second flight, broken fuse, motor and ESC, the rest ok as I cut throttle as it was rolling directly to ground!!!!!!!! I didn't even complain to HK as I don't expect anything from them, I just wrote this revieThis model is absolute crap and I requested that it be withdrawn from sale.There are too many problems to list individually. Save your money and buy something else!