Diventa fornitore Blog Nuovi oggetti
Registrati

Prezzo totale

0,00 €

Carrello della spesa 0 Carrello della spesa 0 Loading...

PDI-HV0903MG

Generating Links

PDI-HV0903MG

Prezzo:

Now save risparmia 0,00 € 0,00 €

14,52 €
Già acquistato Discontinued Product

Please continue searching for a similar product.
SKU:
458000009-0
Spedizione gratuita? Clicca qui per saperne di più!

KS-Servo PDI-HV0903MG, slim wing, metal gear, 2.6kg / 0.07sec /9g

These servos are high quality with metal gears and with their slim design make them perfect for small gliders, planes and helis.

Features:
• Excellent torque and speed
• Metal geared
• Twin ball bearings
• Perfect servos for small gliders, planes and helis
• Complete mounting hardware pack 

Specs:
Model: PDI-HV0903MG
Operating Voltage: 6V / 7.4V
Operating Current: 100mA / 190mA
Operating Speed: 0.09sec.60º/ 0.07sec.60º
Stall Torque: 2kg.cm / 2.6kg.cm
Dead Band: 2usec
Operating Travel: 60º
Bearing: Dual Ball Bearing
Gear Material: Metal
Connector Wire: 150mm
Operating Temperature Range: -20c+60c
Spline Count: 15
Size: 23.5 x 8.1 x 24.3mm
Weight: 9g

attributeset-11
Close

Dimension Diagram Guide

  • attributeset-11

Close

Carica video

Registrati per caricare video, per favore accedi o registrati

Temi
Ordina per
Argomenti più recenti
* Nickname:

* La tua risposta:


Si prega di inserire il testo mostrato nell'immagine nel campo sottostante
*Codice di verifica:
Annulla
Invia
Pubblica un nuovo argomento
* Nickname:

* Il tuo argomento:



Si prega di inserire il testo mostrato nell'immagine nel campo sottostante
*Codice di verifica:
Pubblica argomento

Registrati per scrivere recensioni, per favore accedi o registrati

Walt | Acquirente verificato

  • Overall
  • Quality
  • Value

HVO903mg

Jan 25, 2020

Works as advertised--used to install flaps on Apprentice S

randy | Acquirente verificato

  • Overall
  • Quality
  • Value

nice wing servo reasonable price

Dec 02, 2019

good alternative to hitec.Get 3 for the price of one hitec

Max | Acquirente verificato

  • Overall
  • Quality
  • Value

small servo

Nov 25, 2019

This is a very small servo, is strong enough

Buy-N-Fly | Acquirente verificato

  • Overall
  • Quality
  • Value

Strong servo for it's size

Oct 10, 2019

I installed 4 of these servos in an RCF Edge V3 39"wingspan foamy. The servos are very light and fast. If you need servos that put out over 2 kg of torque this servo is for you. An added bonus is they are below 10g each including wires and connector. There is a considerable amount of slop at center that is magnified when using long servo arms needed in 3d setups. This however doesn't detract from the accuracy when returning to neutral when powered up. It may be due to the tight 2us deadband at center. My aileron servos jittered at neutral but just tapping on the pushrods immediately stopped the jittering. I fabricated a slotted guide that put a little pressure on the pushrod at neutral that worked well and controlled the aileron jittering. I highly recommend this servo for HV set-ups just don't make the mistake of powering them with the full 3s voltage as you will fry your rx and all servos. I made an adapter that powered my receiver and servos through the lipo balancer tap only utilizing 2 cells of my 3s setup. An alternative would be to use a step-down voltage regulator to lower the 3s voltage to 7 to 8 volts.

Colin | Acquirente verificato

  • Overall
  • Quality
  • Value

Eh

Jun 29, 2019

Works well, but it has the design flaw of not including strain relief for the wires coming out of the case. Had the wires pull straight off the PCB. It's easy to open it up and solder them back on, but I'd expect better from a pricey 9g servo.

Jeff | Acquirente verificato

  • Overall
  • Quality
  • Value

I bought 2 of these, one worked fine, the other didn’t work at all, checked the servo and found that the black wire was not connected. Planning to send it back,

May 27, 2019

Black wire was not connected

Walt | Acquirente verificato

  • Overall
  • Quality
  • Value

Wing Servos

Apr 21, 2019

Excellent wing servos for narrow profile wings

Caricare un file

Registrati per caricare i file.
Per favore accedi o registrati per iniziare subito ad aiutare gli hobbisti!