Diventa fornitore Blog Nuovi oggetti
Registrati

Prezzo totale

0,00 €

Carrello della spesa 0 Carrello della spesa 0 Loading...

Pilatus PC-9 Warbird Trainer 1.200 millimetri (PNF)

Generating Links

Pilatus PC-9 Warbird Trainer 1.200 millimetri (PNF)

Prezzo:

Now save risparmia 0,00 € 0,00 €

196,25 €
Già acquistato Discontinued Product

Please continue searching for a similar product.
SKU:
267000001-0
Spedizione gratuita? Clicca qui per saperne di più!

Il Pilatus PC-9 è una versione migliorata del precedente PC-7 anche se caratterizzato da un abitacolo più grande con seggiolini eiettabili, motore più potente, e una serie di miglioramenti strutturali. E 'stato usato da numerosi paesi come un velivolo da addestramento avanzato. E 'stato anche costruito su licenza da Beechcraft e utilizzato dalla United States Air Force come il T-6A Texan II.

Il nostro PC-9 arriva in un tappo e volare formato, solo bisogno di un po 'di assemblaggio di base, installare la vostra scelta di batteria e sistema radio per essere pronti a prendere il volo. La cellula EPO completamente modellato va di pari passo rapidamente e facilmente con un minimo sforzo, solo un paio di utensili a mano richiesto. dettagli Scale Aggiungi al realismo di questo modello tra cui antenne, linee dei pannelli, e una bella Elica 4 pale. carrello triciclo retrattile dà assistenza a terra eccellente anche su terreni più ruvida.

Le maggiori dimensioni significa che gestirà più vento, è abbastanza stabile, e impressionare tutti al campo. L'accesso all'interno della fusoliera per installare la batteria è attraverso un grande portello di accesso che si apre e si chiude destra dal trasmettitore! Il Comitato è pre-cablato con un connettore XT-60 pronti ad accettare il tuo 4S 14.8V 2200 ~ 2600mAh lipo. Dopo di che, basta semplicemente inserire nella vostra scelta di trasmettitore a 6 canali e il ricevitore, fare l'installazione finale e volare!

Caratteristiche:
• Plug and fly modello - è sufficiente aggiungere la vostra scelta di batterie e radio
• cellula EPO completamente modellato
• Scala Elica 4 pale
• Facilità di montaggio, in breve tempo di costruzione
• ingranaggio principale retrattile
• Ampio facile accesso coperchio della batteria con una caratteristica aperta a distanza
• Warbird come prestazioni con grande maneggevolezza a bassa velocità

Specifiche:
Apertura alare: 1.200 millimetri
Lunghezza: 1.200 millimetri
Peso di volo: 1800g
Servi: 6 x9g micro
Motore: 3648 650 kv Outrunner
ESC: 45A Brushless

richiesto:
6 trasmettitore e il ricevitore Canale
4S 14.8V 2200 ~ 2600mAh Lipoly batteria w connettore / XT60

Carica video

Registrati per caricare video, per favore accedi o registrati

Temi
Ordina per
Argomenti più recenti
* Nickname:

* La tua risposta:


Si prega di inserire il testo mostrato nell'immagine nel campo sottostante
*Codice di verifica:
Annulla
Invia
Pubblica un nuovo argomento
* Nickname:

* Il tuo argomento:



Si prega di inserire il testo mostrato nell'immagine nel campo sottostante
*Codice di verifica:
Pubblica argomento

Registrati per scrivere recensioni, per favore accedi o registrati

Chris | Acquirente verificato

  • Overall
  • Quality
  • Value

Customer Rated

Dec 28, 2015

Poor quality. Only three of the servos leads were labelled, leaving you to guess where they go. Canopy, retracts and motor would not work. ESC is obnoxious with the continual beeping and carrying on. Paint doesn't match up between the two wings. Would not recommend.

Kai | Acquirente verificato

  • Overall
  • Quality
  • Value

Customer Rated

Dec 20, 2015

Decent model by Unique Planes.
Flys a lot like a Trojan, but isn't one... so if you're looking for something a bit different, the PC-9/Texan II might be it.
Build quality is pretty good.. I found a decent build video on YT and had the thing ready to fly in about 40 mins.
Maiden wasn't too scary. Had a low-moderately windy day, but the PC-9 seemed stable.
All in all, not a bad trainer-type "warbird". Good alternative to the T28, anyway.

Oliver | Acquirente verificato

  • Overall
  • Quality
  • Value

Customer Rated

Dec 06, 2015

Habe 4 Stck im cyber-sale gekauft. Der Aufbau ist einfach aber das Bugrad vom Fahrwerk musste bei 3 von 4 Fliegern nachgearbeitet werden. Die Anlenkung vom Bugrad ber einen Nylonfaden ist nicht sehr haltbar und wenig przise. Wenn alle Widrigkeiten des Aufbaus berwunden sind hat man ein recht gutmtiges Fluggert. Ersatzteile sucht man jedoch vergeblich, da muss man sich anderweitig helfen.

Tovin | Acquirente verificato

  • Overall
  • Quality
  • Value

Customer Rated

Aug 31, 2015

Bought this plane during the half year sales at very good price, still very cheap with the added shipping cost added which local RC shop selling at double the price. This plane is very stable and easy handle, flying similar like a trainer. It can cruise at very slow throttle speed even at 50pcnt throttle with the original speed controller, motor and prop. Very efficient even with 4S 2600mah lipo, can get 8 minutes of flight time with average 65pcnt throttle. It can also cruise at higher speed like a war plane very good flight characteristic with easy take off and very smooth landing. The CG is at 2~3cm from the edge of wing depending the size of battery. Will need to cut the internal fuselage for correct placement of battery close to the elevator & rudder servo. With the correct CG it needs only very little trim and first take off is almost spot on on CG.

Frank | Acquirente verificato

  • Overall
  • Quality
  • Value

Customer Rated

Aug 01, 2015

As much as I like this plane, the quality is just substandard. I've had six flights out of it, took it home and was going to take it out to fix the landing, and the landing gear control box won't work. I can't raise or lower the retracts and I went through all the connection with a voltage tester and there is simply no output to the gear servos. Problem now is that all the landing gear servos run off of two wires, of unknown voltage, the control box has the switches that reverse and -, and again there are no parts. I must now replace the complete landing gear set. I cannot recommend a purchase of this product now.

| Acquirente verificato

  • Overall
  • Quality
  • Value

Certified Buyer Rated

Jul 31, 2015

one servo broke while setting it up,so i replaced it, in addition I replaced elevator servos (same bad quality) and really bad when it gives up, I do not understand the purpose of the electric canopy.

The CG is, if you put everything where constructor meant it to be, in front of the leading edge, you really cant get it far back.

Wing is very soft and bends massively in the Air, reinforced with carbon,

Considering the price, its not good, but ok

Frank | Acquirente verificato

  • Overall
  • Quality
  • Value

Customer Rated

Jul 29, 2015

Flown it now and it flys very nice. Very stable. There is no CG anywhere listed but I used a 4S 2200mah battery, which fit perfect, in the middle of the area for it and did have to adjust for nose heavy, but then it was fine. The landing gear, which is very solid is another pain that has to be fixed. the right wing gear is off by 10degrees and the nose gear is very loose causing the plane to take-off in an S curve badly. Power from the motor is good and so is speed, but the prop is 10.5X8 4 blade and that will have to change because of no replacements. Nose cone broke on first takeoff attempt when front gear compressed and hit the ground.
Looks good, flys fine, but has lots of issues and problems before you put it in the air. You are getting a plane made on Friday just before going home. Fix it and you'll like it. Not worth more than the sale price.

Frank | Acquirente verificato

  • Overall
  • Quality
  • Value

Customer Rated

Jul 27, 2015

arrived safe and sound, packing was very good.
Instructions are what brings the rating down here, they are terrible. You are better off figuring it out on your own.
While its a nice idea to lift the canopy/battery hatch, it's not pratical because there are not wiring assignments/instruction on how everything is connected. Then the gear door servo is backwards - closes when it should open the door so that function now requires a servo reverser.
The fuselage and landing gear seam pretty robust. To put the whole thing together took maybe an hour. To figure out the wiring, 6 hours.
Now I just hope it flys well. Will report further.

David | Acquirente verificato

  • Overall
  • Quality
  • Value

Customer Rated

May 09, 2015

Retracts do not (always) function.
Manual sucks (google translate) and is missing useful information:
- CG is not mentioned
- rudder throws not mentioned
- no explanation about the landing gear

Roy | Acquirente verificato

  • Overall
  • Quality
  • Value

Customer Rated

Apr 10, 2015

This model has no C of G shown any where and the discussion section shows two different locations, in my opinion very poor.
The front landing gear leg has suspension which seems to work fine, but the grub screw that holds the servo horn to the front leg is into plastic only which means the steering nose wheel is not held correctly and the nose leg turns 90 degrees on take off flipping the aircraft onto its back.
Then where the front wheel bracket is held onto the bottom of the nose leg appears to be riveted but it has not held and the front wheel still turns sideways.
This weekend will be my fifth attempt to get this plane into the air, extremely disappointed with the quality seems poorly thought out.................

Roy Jury

  1. 1
  2. 2
Caricare un file

Registrati per caricare i file.
Per favore accedi o registrati per iniziare subito ad aiutare gli hobbisti!