Chiunque che vola per la piccola 250 quad classe è passato attraverso alcuni oggetti di scena, se si sta cercando di adattarsi attraverso qualcosa o ha avuto un contrattempo acro. Queste guardie prop si adatteranno alla maggior parte dei 250 telai di classe tramite i bulloni di montaggio del motore. Le guardie non solo contribuire a salvare i vostri oggetti di scena, ma aiutare a proteggere gli altri e la proprietà dagli alti puntelli velocità da 5 pollici.
• Adattabile alla maggior parte dei telai
• Peso leggero e resistente G10
• Protegge i vostri oggetti di scena e la proprietà
Dimensioni: Per 5 puntelli pollici
Peso: 4.5g ogni
Montaggio: Via del motore 12,16,19mm di montaggio
tried on a 250 quad. usefull only to keep the grass far from the props. Not so resistant.Buenos para empezar y proteger algo las helices. Ligeros. No soportan golpes fuertes.I put these on my Tarot 200 mini quad and they work great for me, because I'm a beginnerNur f?r Indor geeignet, bei einen Absturz brechen die Teile sehr schnellI bought 20 sets for use on 250 drones middles school student were building. Still broke props but not as many as I would have. Paid for themselves many times over.There is no way to attach them to HK FPV250 without drilling holes. Really thin and easily bending.Used these on my 180mm Diatone ET 180 while learning. I used the 12mm mounting pattern, which worked ok. They are mighty big for 4 props but did the job. They break very easily (despite a smaller quad and modest crashes into fences/grass.). I think they mainly provide some protection against catching the props on walls. Once one of the three connecting segments break, the prop guard tends to shake/oscillate a bit. Some heatshrink and toothpicks are a good temporary fix to extend their life. They flex, which might be good. They are light. Id recommend them to friends learning how to fly. Im not sure how durable theyd be on a 250 class quad.Propellers are not so expensive, but when you start Quad like me this propeller guard are greatI bought a set to put onto a 250 size quad. The holes are offset so they match a Multistar Elite 2204-2300kv. Problem is the offset hole pattern means the wires run off to the same side, instead of having a choice where the wires run. In the interest of protecting the wires I omitted the prop guards.
If the guards were slotted instead of drilled, like the quad frames are, then the motor would not be forced into a single position.
I COULD have chose to route the wires where the guards would have forced them to run without problem, but I would rather have a little protection to the wires from the frame. I would buy a redesigned set with slots instead of holes.
The material is light and will offer only some protection. A stiffer, thicker guard would be welcome too.i got two set and glued them with supper glue. I'm using them on my fpv250 orange ghost they help with tipping over and breaking props looks good too but yes I would get 2 or more set and glue them