Quasi a buon mercato come un vero e proprio su ebay! Questo fantastico Mig 29 non è solo veloce, è praticamente indistruttibile. Realizzato in schiuma EPP dura e colorati in laminato, è stato tagliato a laser per l'assemblaggio di precisione e per un look contorno scala in aria.
Fornito con fibra di carbonio di rinforzo, aste di metallo spinta e un motore di plastica montaggio, tutto ha bisogno è alcuni servi, un motore, ESC, il ricevitore e un pacchetto 3S e sarà perfetto per quei giorni di volo in cui si desidera solo per strappare un buco nel cielo.
Lunghezza: 950 millimetri
Apertura alare: 650 millimetri
Motore: 2208 - 2212size 2000-2600kv
Servi: 9g x 2
Prop: 5-6 pollici
Batteria: 2200mAh 3S
Now that i have finally built this kit, i thought it'd be a good time to review.
I usually work with depron sheets so this foam board was a new challenge. It's nicely cut and all pieces fit together very well. I'm running mine on a 2200kv motor on 4s with a 5x5 prop. The plastic motor mount provided help with this setup as it grips to the foam board tightly. I've added rudders and ailerons that help a lot with acrobatic flight and flat spins etc. The only part that is a negative with this kit is the paint to control surfaces - You'll have to remove the painted areas where you tape your surfaces or they'll easily come off as the paint separates from the foam board a little too easily. Apart from that, it's a decent kit and saved me cutting out from scratch - i'm getting old i think! If you've built before, this will be a simple build. If not, some common sense and caution must be applied.Looks great and flies well.
The hinge cuts on the elevons were too deep and caused one of them to separate in flight. Thankfully I managed to recover the aircraft with no major damage. Reinforced the hinges with tape and it now performs as expected.I love this plane! Super durable! It has taken many rough landings. Easy to build (Gorilla Glue) It works well with a 2204 2100kv motor and a little 4 inch triple blade prop. With this little 4 inch prop, the blade tips don't extend below the body, so they cannot hit the ground. It flies with a 1000mAh to 2200mAh 3cell.
The CG needs to be a little farther forward than recommended.
Also, I gave mine a bit of a nose-job. (trimmed it back a little)
I would prefer to have pull to positive on the control surfaces, but it still works as is.
Also, this foam is amazing! I would like to buy some sheets of it!This plane is fun to fly, it can fly very fast but it can fly slow as wel.
I have got a 2600kv motor in it and use a 2200 3s lipo from turnigy.
You have to use a lot of expo on it because the elevons are sensetive at speed but you need the bigger throws at low speed and landings.
I am thinking to ad a rudder funktion to it.Test flight of Hobbyking Mig-29 foambard kit.
Motor - BL 2208 2150KV (From Floater Jet glider plane)
ESC - 30A
Servo - 2 x 9g
Battery - 2200mah 3s 25c
Propeller - 6x4
Easy to fly
It can glide
Long flying time
Needs higher KV motor for more speed
Needs additional aileron for the main wing to do fast rolls