SCM 3213 950kv Brushless Outrunner

• Overall
• Quality
• Value

Certified Buyer Rated

Jan 21, 2012

NICE MOTOR AND GREAT POWER FOR PIAGET

• Overall
• Quality
• Value

Customer Rated

Dec 30, 2011

I purchased four of these motors around a two weeks ago (Dec 2011). The price is right for the motors but not the quality.
All my motors sound different and also not smooth. I am not sure if everyone has the same problem like i have with these motors.

• Overall
• Quality
• Value

Customer Rated

Mar 18, 2011

Du par la qualit des accessoires fournis. Impossible de mettre le propsaver sans rusiner la pice. Les pas de vis sont morts sur 2 moteurs...

• Overall
• Quality
• Value

Customer Rated

Feb 12, 2011

Very nicely made motors, BUT no way to reverse shaft orientation. I was planning to use them on a multicopter, but like they are now, it's useless for me.

• Overall
• Quality
• Value

Customer Rated

Sep 29, 2010

Motor is not bad. Replace EXTRA 330 foam, flying weight of 400 g. 2 / 3 of gas go a candle. But there is a problem, the rotor is mounted crooked so only 4 points

• Overall
• Quality
• Value

Certified Buyer Rated

Mar 17, 2010

I use it in Merlin from Multiplex, a little to big small modification necessary but nice and powerfull for vertical fly use in 3s1p 1000mAH Turnigy Lipo

• Overall
• Quality
• Value

Customer Rated

May 07, 2009

great little motor, used it in my little foamies with a 9x3.8 prop. great for park flier of foamies.

• Overall
• Quality
• Value

SCM 3213

Mar 02, 2009

Great little motor, I must have 3 hours flying time on it by now and it's still running good.

• Overall
• Quality
• Value

Customer Rated

Dec 04, 2008

This motor arrived in working condition. However, the rotor touched the stator at one point. Closer inspection showed that the rotor part of this outrunner was wobbling and when power was applied an increased vibration was the result. Low price equals low quality?

• Overall
• Quality
• Value

Customer Rated

Nov 18, 2008

moteur qui a l'air bien sympathique, mais chez moi, il n'y avait pas assez de jeu entre le bobinage et le rotor d'ou risque de court circuit.

dommage aussi qu'il n'y ait pas de support d'helice lorsque l'on utilise le support fourni.