Turnigy Aerodrive SK3 - 3548-840kv Brushless Outrunner Motor

super monter puissant et pas trop gourmand en ?nergie monter sur une aile fx 61 avec h?lice repliable 11x8 pour de long vole FPV

Fliege diesen Motor in meiner MX2 Green 3D 1400mm mit 12X6 APC Style

Das Flugzeug steigt senkrecht, ich bin sehr zufrieden mit dem Motor

Excellent motor! Used this in my 48" Extra 330sc and it performs very well. Tested using 12x6, 13x6.5 and 14x7 wooden props and they all give strong thrust & power to perform 3D acrobatics, though 14x7 gives strongest power.

Also the motor is surprisingly quiet and doesn't make alot of noise which is very nice.

Overall a great motor, highly recommended.

Mounted on a plane HobbyKing MXS EPP / Light 3D Plywood 14x7E prop, the ESC must be 70 amps; flying at a height of 2,300 meters above sea level using a battery of 2,200ma 4s 40c.It provides six minutes of flight combined 3D and pattern.
Incredible engine power and barely heats, coprare more! Youtub: PT_kTyeoHNU

Montado en un avion HobbyKing MXS EPP/Light Plywood 3D con helice 14x7E, el ESC debe de ser de 70 ampers; volando a una altura de 2,300 metros sobre el nivel del mar y usando una bateria de 4s 2,200ma de 40c. proporciona 6 minutos de vuelo combinado de 3D y patron.
Increible potencia y el motor apenas se calienta, coprare ms! Youtub: PT_kTyeoHNU

4 flights so far on my PA XR52. Using a Vox 13x5 prop with a 4S battery the power is great. The previous hyperi*n motor couldnt handle all the knife edge spins and was getting a bit rough, so will need to see how this one holds up. Nice and smooth motor, and seems pretty solid so hopefully it is up to some hard 3D flying!.

One of the front bearings has gone from slightly rumbly when purchased, to rather noisy after only 2 flights. Other than that, its been a good motor so far with great power and a nice finish. Good value for money but the bearing issue stops it being a 5 crown product for me.

Bell was nicely balanced, the prop adaptor is well centered and everything fits great.
Drawing 40A peak with a 12x7 master airscrew prop on 4s.

Mounted with a 12x6 folding prop an 4s configuration is great power for a go discover or a similar class airplane. Ps: I mounted in a Go discover, but I had to modify the inner space of the plane.

I have more SK-series motors in unse and they work very good. No issues so far. Recommended product.

Always bench test electric rc motors, without a prop, first thing I noticed, the rear of the motor warms up, fast, it does accel and decel smooth. Installing it Running a 4 cell, 2600 lipo, 50 amp ESC, 11 x 6 Masterscrew prop. stats are 47 - 48 amp, 565 watts full throttle, pulling 4.7 - 5.1 pounds. Should be good for my 3.5 pound foamy sbach, seeing how I am not a 3D guy ( yet ), just like to do the rolls, inverts, crazy 180's.

Ich habe diesen Motor mit einem 70A Brick in einem Talon verbaut. 12" Prop mit 2x4s 5000mAh.
Funktioniert einwandfrei. Werde aber noch zustzlich ffnungen fr Frischluft schaffen, damit der Regler besser gekhlt wird. Top Motor!