Turnigy T600 Brushless Outrunner per 600 Heli (1400kv)

• Overall
• Quality
• Value

Customer Rated

Sep 05, 2014

Hi, I use this motor on my HK550GT and it runs great on 6S, very powerfull and for my soft 3D flying does the job very well. After 6 min flight it is a little hot, but not too much. I use yep 150 ESC with it and 5000MAh Zippy 40C LiPo. The performance for my opinion is very good.

For motor mounting i had to make a small mod by cutting some carbon frame, but no big deal - very easy to modify and it is worth doing it.

• Overall
• Quality
• Value

Customer Rated

Aug 20, 2014

15 minutes of fligh with a 13T pinion, 2 zippy batteries in parallel 2700mah 6s, throttle at 54pcnt at max point and 12 pitch, obviously not 3D flight but awesome performance of this motor, only issue is that l had to break it apart to apply some CA between the shaft and the stator because after the first flight it got loose

• Overall
• Quality
• Value

Customer Rated

Mar 07, 2014

i purchased one of these for my hk600 heli yes you do have to take a small amount of frame away with a dremel so it misses the rotor it took me 5 minutes to do this its no big deal,well worth the bother for the extra bit

• Overall
• Quality
• Value

Certified Buyer Rated

Nov 19, 2013

awesome power but it will require atleast 150 amp esc, i purchased the turnigy delux 100amp esc and it cant handle this motor with 550mm blades on my new hk550tt fbl. dont use it with anything smaller than 150amo esc. i hope someone read this and dont make the mistake i made .now i have to buy a bigger esc.

• Overall
• Quality
• Value

Certified Buyer Rated

May 11, 2013

Doesn't fit the HK 600GT frame without modification,had it said this wouldn't of brought it.

• Overall
• Quality
• Value

Customer Rated

May 09, 2013

Achtung!
Motor passt nicht in den hier angebotenen HK-600 GT

Advice:
these motor doesnt fit into the HK-600 GT

• Overall
• Quality
• Value

Certified Buyer Rated

May 03, 2013

Second purchase. Fitting to hk550 gt . If it performs as well as the first one I will be stoked.

• Overall
• Quality
• Value

Customer Rated

Mar 12, 2013

This motor only gets a 4 crown for overall rating because it is advertised as a 600 size motor yet does not fit a T-Rex 600 without modification. Frame has to be trimmed to allow for it width but after modification it works just fine in the 600. Also be nice if it included the mounting bolts and a pinion, the included bolts and pinion in T-Rex kits are not the right size.

• Overall
• Quality
• Value

Customer Rated

Dec 09, 2012

I bought this motor last year for my hauya 7 blade 4" edf , and didnt try it till this .What a power house at low cost, though i had to enlarge the housing in the fan to fit it .Well worth ,on 7S i get about 8.5 LB thrust at 127Ap close to 3000Wp .And i gone try it on 8S or 10S to see how much more can I get out it .

• Overall
• Quality
• Value

Certified Buyer Rated

Feb 16, 2012

great product, recommended!