Turnigy stand di spinta e di potenza Analizzatore v2

• Overall
• Quality
• Value

Great Product!

Jun 14, 2017

Top quality!
Battery voltage, drawn amps and watts are displayed; great.
The thrust is displayed through placed strain gauges on the vertical alu bar. The thrust readings seems to be too low in my case - however the measured thrust values can always be used relatively (if needed - well, one could make a translate tabel using a precision weight) . This is a very minor problem. As a power stand, this product performs 5 stars!

• Overall
• Quality
• Value

Certified Buyer Rated

May 24, 2016

A great tool to have when determining the best prop size for your quad and the Peak amps drawn helps determine the best esc size.

• Overall
• Quality
• Value

Customer Rated

Mar 15, 2016

Thrust measuring is not working. It only shows the value "0". No answer from hobbyking since 3 weeks. Poor quality and poor customer service.

• Overall
• Quality
• Value

Customer Rated

Mar 02, 2016

All in all its perfect i just received mine and tested it.
HK if you are planning a version 3 some day if have 3 points to mention:
1st combine thrust and power measuring in 1 system so it can display thrust/watt as well

2nd power the thrust measuring with the battery input like the power monitor
and remove the 5 volt input over the servo signal output (opto ecs), if done people dont need to connect 3 power sources to the system.

3rd may rearrange the plate for the motors to have the screws coming from the measuring plate. in this case no screws are unreachable below the motor.

apart from this: its great

also for people looking up more specs quote from the manual:
thrust range: 1-5000g
max current: 150A
Max power: 6500w

• Overall
• Quality
• Value

Customer Rated

Dec 25, 2015

Good quality, nice design. Just the tool you need to be a professional multicopter or aircraft designer. No more hesitation choosing propeller or voltage battery. Thanks HK.

• Overall
• Quality
• Value

Customer Rated

Nov 04, 2015

I received mine yesterday and really like the design and build quality. I like Hobbyking and generally have few issues with there products or customer support. I do understand that was probably the first batch of these. I hooked mine up and the led for the throttle adjust would not come on, and it would not function. Before giving up and contacting HK, I took the cover back off and had a quick look around. It turned out that the little pcb for the servo lead was installed upside down. I removed the 2 outside screws and flipped it over. If you have the same problem, check and see if the polarity of the servo wire matches the artwork on the outside which is WRB front to back.