Turnigy TGY-113MG Metal Gear Digital Servo 2.2kg / 0.10s / 12g
Coppia a 4.8V: 1,8 kg / cm
Coppia a 6.0V: 2.2kg / cm
Velocità a 4.8V: 0.12 sec / 60 ° a vuoto
Velocità a 6.0V: 0.10 sec / 60 ° a vuoto
Piombo / spina: JR Style 220 millimetri lungo
Cuscinetto a sfere singolo
* Prodotto A Taiwan
Velocità ( Sec / 60deg )
Coppia ( kg) ( min . 0.01kg )
Unit Weight (g):
A ( mm ):
B ( mm )
C ( mm )
D ( mm ):
E ( mm ):
( Mm ) F
i have 3 of them. And experiencing Lag while using them as gimbal servos on pixhawk.
i had another test with wolfbox directly , same problem with all servos. also tested with orangeRx, same problem.
Be aware!I have a problem with these servos. I bought 8 for a 6 servo wing glider (plus 2 in the fuselage), but 8 digital servos draw a lot of current, and with even at idle if the 3S LiPo is under 60pcnt the BEC voltage drops below 5V (my Rx telemetry tells me it does) and servos stop working one or two at a time, at random. The real problem then occurs because when they stop working they go to extreme throws, which makes the model unflyable.
They are all glued in so replacing them now is a big hassle.habe 4 davon gekauft und in meine polywood edge 540t eingebaut. ohne last alles gut. kaum ist das gestnge eingehngt zittern die servos. hatte das problem schon ffters. in der luft mit anliegender strmung hrt es normalerweise auf. nicht bei diesen servos. 2 kronen da das 4.servo so funktioniert wie es soll
steffenI purchased 4 of these and one has already developed a twitch when hitting back to neutral. One doesn't centre correctly when changing from low rates to high which I find a worry. The movement isn't smooth on any of them and seem to jitter through there movement range. still strong servo and fast enough for starting 3D flying. But may need replacements after a while.All 4 servos I received have play, unacceptable. When attached to a control surface (3D plane Addiction in my case) they jitter around the rest position due to play and the nature of the harmonic vibration caused by the feedback to the potentiometer. The servos are useless due to the excessive play in the gears.I would say you can't complain too much for the money, but I bought these for my eflite slick 480 and they don't center well. They also tend to jitter and flutter (elevator and rudder) on the ground but ailerons are fine. They also don't seem to move smoothly, kind of a ratchety type of movement. I don't mind spending more to find something better but I might have to look elsewhere.. ...I bought a servo'm satisfied, strong and fast, just thought I heat up a bit but they are 100pcnt metal gears.Working Great on my Tricopter, No issues with KK 2.1I usually buy TGY-S306G servos and went through alot of them - i couldnt find repacment gears for TGY-S306G so started looking for alternative servos.. found this cheaper and thinking being cheaper would break easier so i bought 10 of these TGY-113MG.. funny thing is ive abused the hell out of one of these servos on my talon tricopter - crashed heaps with tail end smashing into earth - It has not affected this little tough bugger or maybe im lucky but i still have 9 spares and purchased another 6 recently..
CONCLUSION: BEST SERVO FOR PRICE