Turnigy ™ TGY-5513MD DS / MG Servo 12kg / 0.18sec / 54.5g

• Overall
• Quality
• Value

excelent product for my activity

Nov 10, 2019

i use to my speed bait boat,good product

• Overall
• Quality
• Value

of lot I bought I have 3 that vibrate connected to the control surface resulting in a vibration while standing static ion the groundd

Nov 07, 2019

The servos vibrate while unloaded connected with the control surface but as they seem to quieten down once in the air and have not failed as yet. Once I have landed they continue to chatter. I have not returned them as they work but it's a draw for the other club members present as the aircraft is constantly chattering. I will not buy again and prefer the dearer metal geared TGY-4409MD which were not in stock at the time.

• Overall
• Quality
• Value

Ausreichend schnell und stark

Oct 31, 2019

Etwas zu langsam als Lenkservo bei 5V aber mit 6V geht es einigermaßen. Geht leider und sehr stark.

• Overall
• Quality
• Value

Ok

Oct 24, 2019

Ok

• Overall
• Quality
• Value

OK

Sep 30, 2019

Im Großen und Ganzen OK.
Leider haben diese Servos etwas Spiel im Getriebe, also nicht 3d geeignet.

• Overall
• Quality
• Value

Certified Buyer Rated

Sep 06, 2016

Wie gewohnt toll nur sehr hoch, im Std. Size Bereich gibt es fast den gleichen Servo nur 1cm niedriger,,..

L?uft bisher gut...

• Overall
• Quality
• Value

Certified Buyer Rated

Oct 20, 2015

Use these servos everywhere, 1.5A amps when blocked, remembers this when bying power distributor.

Very happy with them. Use on a Edge 2m

• Overall
• Quality
• Value

Customer Rated

Jun 15, 2015

Servos have a lot of overshoot and poor centering. Gears have a lot of play. I was going to use them in a 1/4 scale edge but changed my mind.

• Overall
• Quality
• Value

Customer Rated

Mar 03, 2015

Stay away from this servo if you want one that lives for more than a few hours.
Mechanical build quality is fine, the electronics / software, however, isn't. The regulation lacks an Integral part in its PID regulation. Even without load on a servo tester, it did not always reach the set point, most of the time it just just stayed close to the desired position and kept humming, as the pulses the control circiut gave to the motor when it was close to the set point were too short to make it move to the desired position. An integral term in the PID controll should address just that.
You can imagine what happens, when it has to drive some load (and yes, it is strong): It permanently drives the motor and never really reaches the setpoint. Hence, the life time is short, mine died after only a few hours of operation. The motor is shortcut now, even though the crappy driving circuit is still fine (was used on a current limited 5V supply).
It could be as simple as adjusting the PID parameters, however this digital servo cannot be programed.

• Overall
• Quality
• Value

Certified Buyer Rated

Dec 11, 2014

Guter Servo. Passgenau, stark und gnstig