Turnigy ™ TGY-565MG alta velocità HV / DS / MG Servo w / involucro in lega di 5kg / 0.05sec / 40g

• Overall
• Quality
• Value

Great Heli rudder servo

Aug 26, 2019

A clone of KST model of same number. Great servo, works at 720 micro second 565 Hz. Recommended.

• Overall
• Quality
• Value

Nice servo

Jul 19, 2019

Modelled on the KST DS565.
Well packed. I've taken case off and gears are properly lubed, no quality issues with casing. No apparent slop. This will be a KST servo with a slightly cheaper board, I'm not expecting any problems, in fact I rekon this servo will be awesome. I'll post results after a few flights with Brain running them at 720micro seconds at max refresh rate.

• Overall
• Quality
• Value

Customer Rated

Jun 09, 2015

it runs nice and give the heli total 3d tail authority, but the quality control is a bit low.
i opened mine after initial flights to check out if the grease in the gear box to discover that it was a bit short of grease, after replenish, while screwing the long bolt back, observed that the walls where the bolts screwed were so thin that with the lightest torque the wall broke and NO more screw point to atach the bolt as it overwiden the hole. I believe that it may be a bad bach of upper case manufactuing. Now my servo only is tighten bolted on two points the other two are useless and i have had to use film tape to keep it tighten.
I would be very much please if hobbyking would send me a upper part of this servo, to leave as it should be and to avoid the jokes of my mates when stared at the servo.