The Phoenix 2400 is the largest glider in the Phoenix range. It comes with an almost indestructible ABS plastic hull and strong EPO foam wings and tail section. With its smooth, stiff hull, the Phoenix is ​​durable for a lifetime and yet light enough for the glider to work without any problems. An additional canopy with camera mount is included. Once you have your camera installed, you can either enjoy FPV flying or just take pictures of your flights.

Assembling the glider is quite easy with no glue required. To make travel easier, the wing halves simply snap into place along with a rigid wing spar for added strength. The main wing is 2,400 millimeters long and contains ailerons and flaps for better aircraft control. The fuselage has a built-in single wheel for easier landing on rougher runways.

The speed controller, brushless outrunner motor and 9 g servos are all pre-installed. It should only take about 20 minutes for the rest of the build to complete, including adding your own receiver and battery.

Features:
• ABS plastic hull
• EPO foam wings with flaps
• Camera mounting platform
• Click and insert the wing assembly
• Fast construction time
• Motor, controller and servos pre-installed

Specs:
Wingspan: 2400mm
Length: 1283mm
Flying weight: 1160g
Motor: 4023-1050kV brushless outrunner
ESC: 40A brushless
Propeller: 10x6 collapsible
Servos: 9g x 6
CoG: 77 +/- 5 mm from the leading edge

Recommended:
2.4GHz 6Ch radio TX / RX system
2200mAh ~ 5000mAh 3S LiPo battery