ASP S21A - マフラーアッシー

• Overall
• Quality
• Value

Certified Buyer Rated

May 17, 2016

Marmitta per motore ASP S21A

• Overall
• Quality
• Value

Certified Buyer Rated

Jul 30, 2014

I am very happy. I have found a muffler for my engine OS .10 FSR it fit perfectly and at a ridiculous price!

Unfortunately I have to buy the two screws M2.5

• Overall
• Quality
• Value

Certified Buyer Rated

Jan 31, 2014

Good quality muffler at a fraction of the price sold anywhere else. I purchased this to fit my Enya 0.19 nitro (glow) engine and it looks like it's going to work. It will not be directly bolted on but instead strapped on since the distance between the bolt holds is inadequate but I knew this before purchasing this muffler and my intention was to strap it on anyway. I will be using coat-hanger wire with the ends bent back into the bolt holes and then bringing the other ends around which will be secured with a short bolt and nut, using washers were needed, through loop holes bent out at those ends. It will take a bit of ingenuity to this but I already had this planned and envisioned in my mind prior to purchasing this muffler. Otherwise the exhaust stack face on the muffler is adequate and mates-up with the exhaust stack on the Enya 0.19 fine. The measurements of this muffler are as follows: center-to-center bolt spacing is 27.5mm (1.08") , overall spacing (length) of the exhaust stack face is 34mm (1.34") , width of the stack face is 8mm (0.31") , length of the stack neck is 20mm (0.79") . The two bolt holes are threaded and use 2.5mm (M2.5) bolts.

• Overall
• Quality
• Value

Customer Rated

Apr 29, 2012

Exellent Value for Money. For those wishing to use on other brands of engine the bolt holes are 28mm centers and they do not have any Baffles in them.