BMS-303-JSTウルトラマイクロサーボ0.7キロ/ .11sec / 3.4グラム

• Overall
• Quality
• Value

Customer Rated

Jun 05, 2013

Overall good servo, somewhat sloppy but resistant gears.
Price is overestimated and should be lower for this size and quality.
Used them in F5 400 class with some problems (one servo became jerky after circa 100 flights). Now have two of them in 1,5 m flying wing.

• Overall
• Quality
• Value

Certified Buyer Rated

May 13, 2013

very good servo, speed, centeruing, resolution are very fine!

• Overall
• Quality
• Value

Certified Buyer Rated

Nov 21, 2012

Very nice servo, I use the Indoor model airplane.

connector is not compatible with 2.4Ghz FHSS Compatible A-Micro 5CH Receiver (Hitec Minima compatible) has different dimensions (therefore the 4 stars)

• Overall
• Quality
• Value

Certified Buyer Rated

May 29, 2011

exactly the same as the bms303 just got lighter jst plug brilliant servo

• Overall
• Quality
• Value

Customer Rated

May 18, 2010

Great servo for it's price and weight.

A lot better than the 2,5g jst servo both in resolution, power, speed and precision.

So if you can handle the 0,8g more weight this is an excellent option for smaller planes.

Using them in a 60cm scratchbuilt Yak55 weighing 83g rtf. Perfect for 3d where the 2,5g was not strong or precise enough

• Overall
• Quality
• Value

Customer Rated

Jan 28, 2010

The JST mini-connector wiring has not standardized yet, its up to you to verify the correct polarity.

• Overall
• Quality
• Value

Customer Rated

Jan 28, 2010

The JST mini-connector wiring has not standardized yet, its up to you to verify the correct polarity.

• Overall
• Quality
• Value

Certified Buyer Rated

Nov 17, 2009

Changing red and black cables for operation with ar6300 was easy. A hobby knife is all you need.

• Overall
• Quality
• Value

Certified Buyer Rated

Nov 13, 2009

Super micro servo using on my 50g micro flyer. Fits the plane perfectly!

• Overall
• Quality
• Value

Customer Rated

Nov 10, 2009

Despite reading about the wiring issues, I plugged them into my AR6300 without changing the wires around. Anyway, despite the strong smell of burning electronics they still perform quite well (after swapping the black and red wire around). However, the JST plugs are very difficult to extract and tugging on the wires is not an option as they tend to break or pull out from the plug. I also broke one of the gears recently during a landing.