ブラシレスアウトランナーTowerPro-A2409-18 1000kv / 180W

• Overall
• Quality
• Value

Certified Buyer Rated

Feb 18, 2012

Habe den Motor bereits 1mal in meiner Minimoa. Satte Leistung bei leichtem Gewicht. 5*

• Overall
• Quality
• Value

Certified Buyer Rated

Jan 30, 2012

Outrunner Brushless TowerPro-A2409-18 1000kv / 180W .. a very solid motor capable of lifting loads up to 900gram .. suitable for 3D airplane and flying slowly

• Overall
• Quality
• Value

Customer Rated

Dec 20, 2011

Mine stays for a while in my sparebox And I want to instal it on an EPO ultimate 3D. It looks like on the picture except it is maked 2409 - 12 "delta" (not 18 like here but the mounts is this yellow one...?!)

I try to turn the axe in order to have the boutrunner bel in the front but it seems that, despite the screw is off, this bell is glued on the axis.
Wher can I find instruction to operate safely?
Thanks
Eric

• Overall
• Quality
• Value

Certified Buyer Rated

Sep 22, 2011

Reliable motor glider flew 1000g, measurement data is not available.

• Overall
• Quality
• Value

Customer Rated

Aug 31, 2011

I have bought many motors from HK, and I have to say I did not like this one at all. It just was not the quality that I have seen with their other motors. I guess I can say you get what you pay for sometimes, but I normally get great products from HK. I may have just got a bad motor.

• Overall
• Quality
• Value

Customer Rated

May 01, 2011

I`ve bought 4 of them 1 Year Ago . All i Can say "AMAZING" !

I put 2 of them in a MPX Twinstar with 9x3.8 props .
50 Gas and the Twin goes Vertical to the clouds !

Powerconsumption less 15A !!!

1 brocken Shaft in 90 Flights !

• Overall
• Quality
• Value

Customer Rated

Feb 19, 2011

Type your review here.
Try to include as much data as possible.
Lovely motor,I have 2 of these, being used in a 36 foamie 3d. A little heavy but very robust, been flying them for about 2 years now, no problems. apc 10x4, 1.6ah,8 min runtime, I fly hard 3d. Highly recommended.

• Overall
• Quality
• Value

Customer Rated

Dec 29, 2010

Has lots of power. After a short time, I smelled a burning odor. In touching the motor case, I burned my finger. I do not have equipment to check power consumption, but I checked the motor temp with an IR sensor and it was over 225 degrees F. It got hot enough to scorch the wood of the motor mount. I was using a Turnigy 3s 2200 mah Lipo w/HobbyKing 25-30A ESC and swinging a 10x4.5 SF prop. Now I have to decide whether it's worth spending about 7 bucks to return a 13-dollar motor. Am I throwing good money after bad?

• Overall
• Quality
• Value

Certified Buyer Rated

Oct 22, 2010

perfekt for 3D flying with Super Zoom

• Overall
• Quality
• Value

Customer Rated

Oct 13, 2010

Does HK sell a motor mount for this motor? If not is there one that can be bought somewhere else