コントロールアームの63ミリメートル（クリニーク/袋）

• Overall
• Quality
• Value

Customer Rated

Jun 02, 2015

5/31/15
These work on 65MG's and if you trim a little material from the tail end it will allow the hole to close a little smaller if needed. Next to the last hole at each end is 1" from center. It's kind of nice not needing the servo screw anymore.

• Overall
• Quality
• Value

Customer Rated

Jan 22, 2010

There some dimension, you can print 1:1

http://www.hobbycity.com/hobbycity/forum/uploads/5417/Control_Arms_63mm.pdf