ESUN 3Dプリンターフィラメントオレンジ1.75ミリメートルPLA 1KGロール

• Overall
• Quality
• Value

Not pure PLA

Jan 06, 2019

Sure wish I had read the previous reviews before I bought this. It stinks a little like ABS nothing like PLA. It also requires a higher temperature to bond the layers.Printed a 12hr part that delaminated into fine threads. It peels off the table before a model of some size (large) is finished unless you make special measure to make it stick. At one time after the extruder had heated up but before the print started, withdrew from the extruder by it's on tension. Shame the flashy brochure and fancy spool aren't matched by the quality of the filament.

• Overall
• Quality
• Value

Never again

Oct 08, 2018

I ordered this filament, to print some jack o lanterns in preparation for Halloween. I printed a small one, for testing, and everything went fine. After that I started a 10 h print by printing 2 big jack o lanterns. I woke in the middle of the night hearing click-click from the printer, the filament snapped. My jacks were decapitated, so I had to reprint the top parts, and attach them to the jacks.
I've read online articles about brittle filament, and thought, "hm, maybe I need to dry out the filament" so I baked it at 50C for a couple of hours. I loaded the presumably now good filament, but had the same result.
If you want a filament you can load, and start a long print, without any doubt, DON'T buy this, DO buy Hobbyking filament instead.
This filament is a £12+12 mistake I'll never make again.

• Overall
• Quality
• Value

Good filament, terrible color

Dec 05, 2016

Good PLA, likes to be printed quite hot 210-215C. But absolutely terrible color, looks like a life vest who has been out in the sun for way to long.

• Overall
• Quality
• Value

Customer Rated

Dec 10, 2015

Good filament, but the orange isn't at all as bright as in the picture, looks very boring actually :(

• Overall
• Quality
• Value

Certified Buyer Rated

Oct 15, 2015

Turnigy Fabrikator 3D Printer

Best settings i've found with Cura are: Bed 70C, Nozzle 220C, 50mm/sec, 93pcnt Flow

Prints are good and strong with a

Very high quality material

i find it strong and not at all brittle.