GEPRC GEP-KX5 Elegant Racing Drone Frame (5 Inch) (Kit)

GEPRC GEP-KX5 Elegant 5inch frame is built for both Freestyle flying and Drone Racing. It features True “X” frame design and has a long dual deck built over the “X” arms. The center of gravity is around the battery so that the frame excels in both freestyle flying and racing.

The one piece 4mm 3K carbon fiber arms and top deck have aluminum brackets to add additional strength and support when mounting top deck/arms to the 2mm carbon fiber lower deck. The arms also provide extra protection for your motors. There is a 1mm carbon fiber side frame to keep all the electrics and cables inside the frame.
Up front, there is an aluminum FPV camera frame to keep the FPV camera safe. It also allows easy mounting for an action camera to your frame. The FPV camera mount is for standard 29mm FPV cameras and allows for camera angle adjustment. GEPRC have included a PDB (with BEC 5V / 12V output) with an XT60 connector which helps remove some of the cable clutter. At the back, there is a LED board so that spectators can easily follow your flight.

Just connect up your favorite F4 Flight Controller, 20~35A ESCs and 2205~2306 motors powered by 3S~4S 1300mAh to get you spinning.

Add your FPV gear to the frame for some extreme racing and gravity-defying freestyling.

Features:
• Exciting design for Freestyle and Racing
• True “X” structure
• 3K high strength carbon fiber arms and upper deck (4mm) and lower deck (2mm)
• Narrow motor arms (14mm) to reduce wind resistance
• #7075 aviation aluminum frame supporting FPV camera
• More motor protection due to arm design
• Strong and light weight frame structure (115g, including all fixed parts)
• LED board at rear with buzzer
• PDB, with BEC (5/12V)
• Battery mounted on top deck for better balance

Specs:
Wheelbase: 243mm
Size: 205x205mm
Weight: 115g
Arms / Upper deck: 4mm carbon fiber
Bottom deck: 2mm carbon fiber
Side frame: 1mm carbon fiber

Included:
1 x GEP-KX5 Elegant frame kit
1 x PDB w/BEC, XT60
1 x LED Board
2 x Battery strap
1 x Build guide

Recommended:
1 x Flight Controller: F3/Naze32/CC3D
4 x 2205/2206/2305/2306 Motors
4 x 20A-35A ESCs
4 x 5inch Propellers
1 x 3S 1300mAh ~ 4S 1500mAh Battery
1 x 5~6 Channel Radio Tx/RX
1 x FPV setup (optional)

*** Note.  This is the frame kit only.  Additional items as pictured are not included. ***