HobbyKing 4WDビッグモンスター1 /第五スケールトラック（ARR）（米国倉庫）

• Overall
• Quality
• Value

Customer Rated

Dec 10, 2013

I bought the gears to try and fix these two trucks and the gears they sell DONT WORK.They DONT fit.So if you got screwed like i did DONT waist your time and money trying to fix it.You can use the engine and servos and battery and throw the rest in the trash.AGAIN DONT BUY THIS PIECE OF GARBAGE !!!!!

• Overall
• Quality
• Value

Customer Rated

Feb 21, 2013

I realy got ****** i bought two of these pieces Of garbage and both broke within 10 minutes.They dont have all the parts for it so dont waste your money or spend days trying to get hobbyking to give you any support.Hobbyking dont give a dam about there customers and thats forsure,i know cause they screwed me real good and what can i do,go to china for help or support,i dont think so.So when you hear them talk about all this support that they do,its a straight out lie,DONT BUY THIS TRUCK,and dont exspect any support from anything else they sell.dont let them screw you because they do it every day.They should be banded from the United States period!!!!!!!!!!!!!!!!!

• Overall
• Quality
• Value

Certified Buyer Rated

Aug 01, 2012

broke after 20 min run time rear diff will not turn

• Overall
• Quality
• Value

Customer Rated

Jan 09, 2012

Finaly got new front tires. Have run 4 tanks of gas so far 25-1 oil gas mix

this truck will fly. I havr flowen RC planes for 40 years and this is my first truck it is faster than some of my planes. Love IT!

• Overall
• Quality
• Value

Customer Rated

Aug 10, 2011

Strait off the bat I want to say excellent value for money.

That being said, it is not perfect out of the box and there is a fair amount of work to do out of the box before you start it up.

First thing to do is take off all the wheels, you will see aluminum blocks with 2 set screws. The shaft is keyed for the set screws but on two wheels I found that the block wasn't tightened onto the keying. I would recommend blue thread lock on these set screws as well. If you fail to do this it will work the wheel nut off the shaft and the wheel will fall off on one side and over tighten on the other.

I would do a good look over the whole car for loose screws, one that I lost was the screw holding on the front sway bar to the lower arm.

On mine the clutch dragged on the bell out of the box. I took the screws off holding the bell and it seems to be because the bell wasn't aligned properly. I aligned it as best I could but couldn't get it perfect. At idle the clutch still drags slightly but not enough to move the truck. I'm hoping it will wear enough eventually to stop.

Also watch out for the oil that comes with the truck, on mine the air filter oil bottle had come open and the oil was in the vacuum sealed bag.

You will probably want to oil the shocks too, mine seemed dry out of the box but I haven't made it to filling them quite yet.

The truck came with a manual which wasn't anything