HobbyKingオンボードスマートグロードライバー

• Overall
• Quality
• Value

geras daiktas

Oct 31, 2021

pirkčiau dar jei būtų Europos sandėlyje

• Overall
• Quality
• Value

contrôleur allumeur https://youtu.be/5pahLxekBGA

Jul 29, 2018

après plusieurs essais je confirme le seul programme efficace est le 1° ma premiere impression était fausse
les autre s'annule des la coupure récepteur en faisan un montage
avec cordon( y) entre servo et glow pilote via manche emetteur le système marche en automatique sans aucun problème mon moteur 4 temps acheté chez HB fonctionne au mélange alternatif 20%huile 10%sp98 70%methanol voir vidéos . vraiment efficace !!!!!!!!
youtubehttps://youtu.be/5pahLxekBGA

• Overall
• Quality
• Value

contrôleur allumeur pas top

Jul 21, 2018

il ni a pas 10 fonction ??????? rien n'est programmable
il est possible de brancher avec un y mes faut magouiller avec servo gaz et allumeur
pas de possibilité de régler le temps d'allumage en fait vous ne pouvez rien controller .allumage direct de zero a mis gaz et arrêt a plein gaz
de plus faut rajouter un inter pour controller avant le démarrage

• Overall
• Quality
• Value

OK

Oct 09, 2017

I used a 3-way switch on my Futaba TX and plugged it in channel 5 of my Futaba 7 channel RX .I powered the glow plug with a separated 2S Lipo battery and connected a switch on the main lead to shut off the power supply when not flying.
Works great and gives a reliable feeling while the engine is in idling mode.

• Overall
• Quality
• Value

Customer Rated

Jul 18, 2016

I bought one of these a while back and it worked great. I have it on a plane and it is controlled from a switch on the transmitter just like the instructions say. So I ordered four more for my other airplanes. None of the four worked. They do not respond to commands from the transmitter/receiver. I filled out an RMA to return them. I sent them a picture but they told me to make a video. What a pain. Not worth the trouble.

• Overall
• Quality
• Value

Customer Rated

Jul 12, 2016

Starts off I will have to say it only has 3 modes, Not 10. If HK can put up a manual that shows how there are 10 it would be Great. As all I can get is 3. I'm run it as a on/off on a OS 120 4 stroke. Use it with my RX and powering it with a separate battery. It does work good this way. Turn it on ( RX ) and after 30 seconds it pulsates on and off, at about every 1/2 second. It is really light wight. I pulled the red wire out of the plug and plugged it in to a separate plug and solderer a black wires together. If that makes cents.
Thanks Dan

• Overall
• Quality
• Value

Customer Rated

Jun 01, 2016

I purchased three of these. I have mounted two and used one fairly extensively.

I'm using mine in transmitter controlled mode with no limit on glow run time (so I can run half power indefinitely should I need to idle for a while). To set that up required shorting two wires on the 'control button' which was an easy task.

I also added a ferrite ring to the receiver line to help filter out the noise from the switch mode converter.

I needed to extend both wires, the driver works normally with 6 inch extensions.

During installation the ground wire's mounting ring broke off when I tightened the engine mount bolt. I had to attach a second terminal, soldered and shrink tubed it uneventfully.

After several runs the plane came back indicating a broken glow filament (3 quick flashes). I discovered the positive lead's solder had failed allowing it to disconnect from the glow head locking mechanism. I disassembled the positive lead's connector and was able to rebuild, solder and again heat shrink it. The unit is working normally again.

If you aren't afraid to work on this unit should you find some substandard stuff going on I think you'll be happy with it. Hopefully this helps some people out there!

• Overall
• Quality
• Value

Certified Buyer Rated

May 17, 2016

Dispositivo elettronico da installare a bordo del vostro modello Aereo, Elicottero, Barca, Auto, Moto provvisto di interruttore Led per l'accensione della vostra Candela . Lo stesso puo' anche essere attivato da un canale libero della vostra ricevente.

• Overall
• Quality
• Value

Customer Rated

Apr 30, 2016

No information provided with the product as to the 10 modes and how to identify which mode if any you are in

• Overall
• Quality
• Value

Customer Rated

Nov 03, 2015

Good device! But there are no instructions.
I use it on the helicopter. Very short:
When you connect the power, led starts blinking seldom. It is standby.
When you press the button - there are five frequent flashes and then the led is illuminated constantlyfor about 30 seconds. In this time the power is supplied on the glow and you can start the engine. After 30 seconds the device will return to standby mode. Do not connect the signal wire from the connector, if you do not plan to include "keep on heating" from the transmitter.