Matek PDB-XPW w/ Current Sensor 140A and Dual BEC (5V and 12V)
Matek PDB-XPW w/ Current Sensor 140A and Dual BEC (5V and 12V)
The Matek PDB-XPW is a power distribution board with punch and is designed for X frames. It will take input from 3S to 5S Lipo batteries which are ideal for Racing Drones. Power is provided to four ESCs and it is regulated and synchronized 5V DC and linear regulated 12V DC for all your gear such as Flight Controllers, cameras, video transmitters, RC receivers, LEDs, etc.
It also has built-in 140A current module and offers an XT60PW socket to connect the LiPo pack conveniently. The PDB fits into typical 30.5x30.5mm tower mounts and has large solder tabs making it easy to install in your drone.
Features:
• 2oz copper, 4-layers & 2mm PCB
• Built-in current sensor 140A
• Built-in XT60PW Socket
• Total 4 pairs ESC solder tabs are fit for X type frame
• 5V and 12V Output LED indicators and short circuit tolerant
• 5V BEC for RC Receivers, Flight controllers, OSD, and Servos
• 12V BEC for Video TX or FPV camera with linear regulator
Specs:
General:
Input voltage range (3S-5S LiPo operation): 9 - 21V DC
PDB: 4 x 35A
Regulated 5V and 12V outputs
Current module: 140A, 3.3V ADC
LED power indicators (5V & 12V outputs)
BEC 5V output:
DC/DC synchronous buck regulator.
Voltage: 5.0 +/- 0.1VDC
Continuous current: 2 Amps (Max.2.5A 10s/minute)
Output Ripple: 40mV (VIn=16V, VOut=5V@2A load)
Short-circuit tolerant: 5 seconds/minute
BEC 12V output:
The battery should be 4~5S LiPo (13~21V DC)
Voltage: 12.0 +/- 0.3VDC
Continuous current: 500mA (Max.0.8A 5s/minute)
Short-circuit tolerant: 2 seconds/minute
BEC 12V @ 3S LiPo
Output voltage= 3S LiPo voltage -1.5V
Physical:
Mounting: 30.5 x 30.5mm, Φ3mm
Dimensions: 36 x 50 x 4 mm (w/o XT60PW), 36 x 58 X10.5mm (w/ XT60PW)
Weight: 8.5g (w/o XT60PW), 13g (w/ XT60PW)
| Matek PDB-XPW Manual | Download [11] |
