マイクロMWCフライト・コントロール・ボードのDSM2互換性のあるESCのX4ブラッシュ統合

• Overall
• Quality
• Value

Customer Rated

May 19, 2016

Was a bit of a pain to solder given the size but man, what a hell of a little FC. On my first battery change I plugged in a battery that was wired backwards which let to a huge spark and a small fire. I immediately unplugged it and plugged in another battery... the thing just kept going like nothing happened.

Would buy again!

RC

• Overall
• Quality
• Value

Customer Rated

Mar 12, 2015

Ich hatte ebenfalls beim ersten Start den Totalausfall aller FETs.
Dadurch wurde das Board fr mich unbrauchbar.

• Overall
• Quality
• Value

Customer Rated

Feb 09, 2015

Quite good product. A bit too expensive.. If you do your homework, you will not burn the FETs. Ive not tried run the stock firmware. Depends on the motors, you need to adjust the config files. My old, micro quad with broken electronics flies again. Does the loops, flips, very stable.

• Overall
• Quality
• Value

Customer Rated

Feb 07, 2015

The Fets (3 of them!) burned out at first motor start. It's a common problem, must be wrong Fet type for the job. I am EE with tools for SMD work, so I replace. But this board is just unusable as it was sold.
Browsing the forums it is a common problem, faulty series.

• Overall
• Quality
• Value

Customer Rated

Sep 12, 2014

First I made a adapter cable to connect the serial port to the PC, using 2 of HK JST-SH 3pin plugs, cutting them into 2 halfs and glueing together for a 4 pin plug. 3.3V level requires a level shifter 3.3V <-> 5V, then it worked perfect.

Preloaded firmware works with my ladybird quad very well, good and stable autolevel, only yaw rate is bit low.

The spektrum RX part works well, bind was quick and successful with my DSM2 HF module.

Would be interesting to have to board even smaller and w/o spektrum HF, so alternative RX modules could be attached (e.g. Jeti sat).

Great, would buy it again!
Henning

• Overall
• Quality
• Value

Customer Rated

May 16, 2014

It does what it says and is really the only brushed multiwii board I could find. I managed to upload and connect the GUI to it but I had to buy a 4-pin JST-SH connector elsewhere and connect that to my FDTI. That said, I really like this board, very stable flight and autolevel capable. Brought new life to my v939.

• Overall
• Quality
• Value

Customer Rated

Nov 18, 2013

Good things:
- It is very small.
- It works.
- Comes with bootloader and software installed.
Bad things:
-The serial connector is not standard an HK WONT SELL THEM.
-If you want to connect the GUI your in trouble.
-If you want to update the soft your in trouble.
-motor drivers have no flyback diode installed.
-The reset line is not connected to DTR so you have to ... be really lucky to update the soft with arduino bootloader.

Summing it:
If you like trouble this is for you.