FabrikatorミニII BLUE M100

• Overall
• Quality
• Value

Fantastic - but a question.

May 21, 2017

Hi ordered one and loved it.. although I'm very good technically (degree in mech/eng) I've never used 3D printers before and after setting it up (as per instructions), levelling the bed,... and 20 mins later I was holding an almost perfectly printed 20mmx20mm reference cube/dice!!! This is Amazing as a print was obtained less then an hour after unboxing with very little fiddling around and experience,!!

I do have a question.. the printer bed does not seem centered. At 50,50 position the nozzle is not exactly at the centre of the bed. It seems off-set by 6-8mm.

When at home position, the nozzle is around 6-8mm off the bed (not over the bed) and at the other end (max X) the bed has a 6-8 mm edge on rhs of nozzle.

This does not affect printing of small objects but I'd like to centre it.... How Do I Do That???

• Overall
• Quality
• Value

Fantastic - but a question.

May 21, 2017

Hi ordered one and loved it.. although I'm very good technically (degree in mech/eng) I've never used 3D printers before and after setting it up (as per instructions), levelling the bed,... and 20 mins later I was holding an almost perfectly printed 20mmx20mm reference cube/dice!!! This is Amazing as a print was obtained less then an hour after unboxing with very little fiddling around and experience,!!

I do have a question.. the printer bed does not seem centered. At 50,50 position the nozzle is not exactly at the centre of the bed. It seems off-set by 6-8mm.

When at home position, the nozzle is around 6-8mm off the bed (not over the bed) and at the other end (max X) the bed has a 6-8 mm edge on rhs of nozzle.

This does not affect printing of small objects but I'd like to centre it.... How Do I Do That???